The Baseboard Management Controller (BMC) web application allows the provisioning of the four host management interfaces. When the host management interfaces are configured, a direct link from BMC is enabled to the EMA/EMA Platform Mode for installing and upgrading the
Use the following procedure to configure the 4 host management interfaces:
Log on to SBC BMC GUI using the IP address configured in one of the previous sections.
Use any one of the following methods to obtain the BMC IP address:
- Configuring SBC 5400 BMC IP Address Via Serial Console
Or
The BMC Main Screen displays:
Navigate to Configuration > Platform Management Network tab. The Platform Management Network Settings screen is displayed.
To learn more about these four media ports and their operational modes, refer to SBC 5400 Media Ports and Operational Modes.
The SBC 5400 platform includes the following configurable media port configurations.
A message prompts you to enter the management IP addresses for a first-time installation.
If the management interfaces have not yet been configured, a warning message displays. Click OK to proceed with the Management Port configuration.
- IPv4 Address, Prefix and Default Gateway
- IPv6 Address, Prefix and Default Gateway
The IPv4 Address, Prefix and Default Gateway should be configured for Management Interface "0." The settings are optional for all other Management Interfaces.
Click Save.
Once you save the changes to the Management IP addresses, the following warning message displays. Note that the changes to the Management IP addresses will only take effect when the SBC application is Installed (or reinstalled if already present). Refer to SBC 5400—Installing Application for more information.
WARNING: If the SBC application is currently installed, then updates to the management interfaces made here will only be reflected after the application is reinstalled.