The EdgeView contains the EdgeView Service Control Center (SCC). The EdgeView SCC can launch an To enable this feature for the With the EdgeView SCC enabled, the If a timeout results in the runtime status not being retrieved, then the To enable the EdgeView SCC, you must configure the EdgeView panel (see the following procedure) according to your When you enter the EdgeView Management ID, you must insert a colon every two characters (00:00:00). Otherwise, the For information about retrieving the EdgeView Management ID, refer to Obtaining and Installing an SBC SWe Lite Production License.Requirements
Configure the Unable to show "metadata-from": No such page "_space_variables" for EdgeView during Initial Setup
To configure the
- Unable to show "metadata-from": No such page "_space_variables"- Running Initial Setup
- Unable to show "metadata-from": No such page "_space_variables"- Running Initial Setup on SBC SWe Lite
When you configure the Initial Ribbon Setup screen, use the following table to configure the EdgeView panel.
When you enter the EdgeView Management ID, you must insert a colon every two characters (00:00:00). Otherwise, the