Page History

The You can provision the four host management interfaces in the Baseboard Management Controller (BMC) web application allows the provisioning of the four host management interfaces. When the host management interfaces they are configured, a direct link from BMC is enabled to the EMA/EMA Platform Mode for installing and upgrading the

Use the following procedure to configure the 4 four host management interfaces:

1. Log on to onto the SBC BMC GUI using the IP address configured in one of the previous sections.

   Tip
   title Tip
   Use any one of the following methods to obtain the BMC IP address: - Configuring SBC 5400 BMC IP Address Via Serial Console Or - Configuring SBC 5400 BMC for Remote Access

   
   The BMC Main Screen displays:
   
   
   

2. Navigate to the Configuration > Platform Management Network tab. The Platform Management Network Settings screen is displayed.

   Tip
   title Tip
   To learn more about these four media ports and their operational modes, refer to SBC 5400 Media Ports and Operational Modes.

   The SBC 5400 platform includes the following configurable media port configurations.

   
   
   
   

   
   

   Tip
   title Tip
   A message prompts you to enter the management IP addresses for a first-time installation.

   
   

3. If the management interfaces have are not yet been configured, a warning message displays. Click OK to proceed with the Management Port configuration.

   Image Modified

   
   

4. Configure the following network settings for all four management interfaces as needed:, and then click Save.
   

   - IPv4 Address, Prefix and Default Gateway
   - IPv6 Address, Prefix and Default Gateway

   Tip
   title Tip
   The You should configure the IPv4 Address, Prefix and Default Gateway should be configured for Management Interface "0." The settings are optional for all other Management Interfaces.

   Click Save.

   
   

   Tip
   title Tip
   Once you save the changes to the Management IP addresses, the following warning message displays. Note that the changes to the Management IP addresses will only take effect when the SBC application is Installed (or reinstalled if already present). Refer to SBC 5400—Installing Application for more information.

   WARNING:

   
   

   Warning
   title Warning
   If the SBC application is currently installed, then

   updates to

   the management interfaces made here

   will

   only

   be reflected

   reflect updates after the application is reinstalled.

   
   

5.  Click Click OK to complete the process.

Related article: