Not supported by SBC SWe Lite in this release.
ASM package updates can be installed by Sonus SBC 1000/2000 System Administrators via the web interface. This functionality is typically used under the following circumstances:
- Updating the Sonus SBC 1000/2000 Communication Service on the ASM
- Installing Lync Cumulative Update (CU) patches on the ASM
- Installing other Roll-up packs such as windows update authorization lists
- Installing approved Third party software (i.e, SDN Listener or Lync debug tools)
- Installing a new BIOS package on the ASM
This update will accept signed windows .msi and .msp files as well as published .pkg files
On this page, we show how to install packages on the ASM via the WebUI.
Installing an ASM Package
Before you Begin
This operation can only be performed when the Sonus SBC 1000/2000 Communication service becomes operational. In other words, only when a valid ASM IP address has been configured either via the Initial Setup or the ASM IP Settings.
This operation can be accessed either via the Tasks tab or the Settings tab:
Tasks and Settings Tabs
- In the WebUI, click the Tasks tab.
In the left navigation pane, under the Application Solution Module, click Install ASM Update.
Install ASM Update
- Select the ASM package file you wish to install
- Click OK
You will be presented with the following popup to confirm the action:
Confirm
- Click OK to install the package
Throughout the installation process, the User interface will dispatch a series of status messages:
Preparing To Install Update
When the installation succeeds, the following status message is dispatched:
Updates Installed
- Should the update be a windows update .pkg pack, refer to the operation status page to initiate windows update install
- If the installation failed a detailed status message indicating the reason for the failure will be displayed
- In the WebUI, click the Settings tab.
In the left navigation pane, go to Application Solution Module > Install ASM Update.
Install ASM Update
- Select the ASM package file you wish to install
- Click OK
You will be presented with the following popup to confirm the action:
Confirm
- Click OK to install the package
Throughout the installation process, the User interface will dispatch a series of status messages:
Preparing To Install Update
When the installation succeeds, the following status message is dispatched:
Updates Installed
- Should the update be a windows update .pkg pack, refer to the operation status page to initiate windows update install
- If the installation failed a detailed status message indicating the reason for the failure will be displayed
Verification Tip
- If you have installed a Sonus SBC 1000/2000 Communication Service update, verify the update by Viewing the Sonus SBC 1000/2000 Communication Service Version.
- If you have installed a Lync CU patch, verify the update by checking the versions of each Lync Service.
- For further information in windows update refer to ASM Roll-up Update
Overview
Content Tools