Upgrading the BMC and BIOS Firmware

This section describes the method to upgrade the SBC 7000 BMC and BIOS firmware. The BMC and BIOS images are bundled into a single firmware package "firmware-7X00-V<release>.img".

The following procedure describes how to upgrade the firmware from the BMC web GUI.

1. Log on to the SBC BMC GUI.


   BMC Login Screen

   

   The BMC main screen is displayed.

   BMC Main Screen

   

2. Click Firmware Update. The Firmware Update screen is displayed.

   Firmware Update Screen

   

3. Click Browse, and from the Open dialog browse to and select the firmware-7X00-V<release>.img firmware image. To determine the exact firmware version, refer to SBC Release Information for the current release notes.
   
   The chosen file displays next to the Browse button.

   Browsing Firmware Image

   

4. Click Upload.

   Note

   The firmware image is a 26 MB file and takes few minutes to upload based on the network. 

5. Once the upload completes, the Firmware Update screen displays the firmware images and versions.

   Uploading Firmware Image

   
   Note

   In the previous screen, if both the Old Version and New Version are same, then the update status displays as "No". 

6. Click Confirm to continue. The upgrade progress bar displays on the screen.

   Note

   This is a service-affecting procedure and will power off the host side of the SBC. 

   After you confirm, the BMC initiates an orderly shutdown of the host. If the process to shutdown the host fails, the upgrade fails. Take one of the following actions based on the current BMC version:

   • If the BMC version is less than 3.18-R000, reboot the BMC by issuing the "reboot" command from the BMC command line. After the BMC boots up, shut down the host manually before continuing with the upgrade.
   • If the BMC version is 3.18-R000 or greater, a reboot is not needed. Power off the host manually before continuing with the upgrade from step 2.

7. After the firmware upgrade completes, the following dialog displays. Click OK to close the message.

   Completing Firmware Upgrade

   
   Note

   Once the upgrade completes, the BMC and host reboot automatically. Verify that the SBC starts and sync with its peer server before proceeding further. 

8. Close the SBC BMC GUI.

9. Clear the browser cache and log on to the BMC GUI again.

10. Log on to the SBC BMC GUI again.
    The SBC BMC prompts you to change the password after a successful upgrade.

    Note

    This change is applicable only when the BMC is upgraded to version 03.13.00 and later versions. 

    
    

    Change Default Password window

    

11. Click OK to proceed. The User Management window is displayed.

    Note

    You have an option to cancel the action. If canceled, the password remains the same as the default password and you are allowed to continue to work on the BMC. However, the warning message is displayed again on your next login to BMC. This reminder continues until the password is changed. Refer to Changing the SBC 7000 BMC Password for the procedure to change the password.

12. Verify the upgraded version in the BMC main screen and ensure the BIOS and BMC versions match the versions listed in the release notes.