DO NOT SHARE THESE DOCS WITH CUSTOMERS!
This is an LA release that will only be provided to a select number of PLM-sanctioned customers (PDFs only). Contact PLM for details.
In this section:
| Common Call Statistics Terminology | |
|---|---|
| Stable Calls | Calls that are established and fully stable (connected and media cut-through type of calls) and will survive a fail-over. This excludes calls in establishing, clearing and updating states which will not survive a fail-over. |
| Active Calls | A snapshot of total number of active calls on the SBC at the point of execution of the status command. This count reflects the actual live calls on the box independent of the state of the call (setup, stable, updating or clearing). |
| Call Attempts | Accumulative number of attempted calls on this system since the last reboot/start-up, including calls where a setup was sent/received, uncompleted calls (calls failed, busy, not answered, etc.) and calls completed (answered). |
| Call Completions | Accumulative number of calls completed on this system since the last reboot/start-up. |
The SBC allows the operator to access data from the current interval and from the interval statistics table related to each object being monitored. The current interval consists of a statistics table entry that is accumulating data for the next interval report. The interval statistics table is a series of statistics table entries containing data from the most recently completed n intervals (where n is the number of intervals in the retention policy configuration).
Note
Refer to Links to Statistics Pages to navigate to a particular EMA or CLI statistics page.
Note
If using the EMS in your network, configure EMS PM data collection intervals for the SBC to be both:
- Equal to or greater than the SBC intervals size, and
- Not less than the SBC interval size multiplied by the SBC number of intervals.
Refer to the Insight EMS User Guide for configuration details.
Note
The SBC intentionally does not display results of all calls when there is a high volume of traffic for the statistics below. This limitation is built into the SBC software to avoid excessive CPU usage and system timeouts.
- sipActiveGroupRegStatus
- sipActiveRegisterNameStatus
- sipDeletedRegisterNameStatus
- sipSigConnStatus
- sipSigTlsSessionStatus
Address Context
Command Syntax
> show table addressContext
cacOffenderStatus
callDetailStatusDetail
callMediaStatusDetail
callSummaryStatusDetail
diamNode
dnsGroup
dynamicBlackList
enhancedDBL
intercept
ipAccessControlList
ipInterfaceGroup
ipRouteStatus
ipsec
linkDetectionGroup
linkDetectionGroupStatistics
linkDetectionGroupStatus
logicalSigAddressBindingStatus
natDirectMediaGroup
realm
relayCurrentStatistics
relayIntervalStatistics
relaySessionStats
rtpServerTable
sipActiveGroupRegStatus
sipActiveGroupRegSummaryStatus
sipActiveRegisterNameStatus
sipDeletedRegStatus
sipDeletedRegisterNameStatus
sipGeneratedSubscriptionStatus
sipRegCountDomainCurStats
sipRegCountDomainIntStats
sipRegCountDomainStats
sipRegCountStatistics
sipSubCountStatistics
sipSubscriptionCountStatistics
sipSubscriptionStatus
staticRoute
surrRegCountStatistics
zone
zoneCurrentStatistics
zoneIntervalStatistics
zoneStatus
set profiles media beepToneProfile <profile_name> direction <ingress | egress | both> durationBetweenTone <0-65535> tonePower <-50-3>
Command Parameters
Address Context Parameters
| Parameter | Description |
|---|---|
| This object displays recent SIP endpoint CAC offender details at the aggregate level (as opposed to the Address Context level) since the last system boot or restart. Go to Show Table Address Context - CAC Offender Status for details. |
| Call status details per address context. Go to Show Table Address Context - Call Status Details for details. |
| Call media status details per address context. Go to Show Table Address Context - Call Status Details for details. |
| Call summary details per address context. Go to Show Table Address Context - Call Status Details for details. |
| Diameter node configuration details. Go to Show Table Address Context - Diameter Node for details. |
| DNS Server Groups in this address context. Go to Show Table Address Context - DNS Group for details. |
| The collection of DBL policers. Go to Show Table Address Context - Dynamic Blacklist for details. |
| The enhanced DBL related operations. Go to Show Table Address Context - Enhanced DBL Status for details. |
intercept | Lawful Intercept Call Data Channel statistics details. Go to Show Table Address Context - Intercept for details. |
| IP Access Control list details for this address context. Go to Show Table Address Context - IP Access Control List for details. |
| IP Interface Group details for this address context. Go to Show Table Address Context - IP Interface Group for details. |
| IP route details including the local IP interfaces and protocols associated with the next hop routes. |
| IPsec configuration, security policy database, IKE peer table. |
| Link Detection Groups in this address context. |
| Statistics for link failure detected per link detection group. |
| The status of a link detection group. |
| The collection of logical signaling address bindings Go to Show Table Address Context - Logical Signaling Address Binding Status |
| Group of Signaling IP Addresses of NAT devices amongst which Direct media is supported |
| A collection of IP endpoints identified by a unique name, where all IP endpoints are mutually reachable by means of IP routing without address translation |
| Relay count current statistics |
| Relay count interval statistics |
| Relay session statistics |
| This table is used to store a list of trusted RTP servers. |
| This table presents the active SIP registration status for a list of SIP endpoints with unique id. |
| This table presents the active SIP registration status summary for a list of SIP endpoints. |
| This table presents the active SIP registration status for a list of SIP endpoints. |
| This table presents the deleted SIP registration status for a list of SIP endpoints with unique id. |
| This table presents the deleted SIP registration status for a list of SIP endpoints. |
| This table presents the active SIP subscription status for a list of SIP endpoints. |
sipRegCountDomainCurStats | This table presents per-domain SIP registration statistics for the current statistics interval. |
sipRegCountDomainIntStats | This table presents per-domain SIP registration interval statistics. |
sipRegCountDomainStats | This table presents registration statistics on a per domain basis. |
| This table presents SIP registration count statistics for the SIP endpoints. |
| This table presents SIP relayed subscription count statistics for the SIP endpoints |
| This table presents SIP subscription count statistics for the SIP endpoints. |
| This table presents the active SIP subscription status for a list of SIP endpoints. |
| Static IP routes for this address context. |
| This table presents Surrogate registration count statistics for the SIP endpoints. Go to Show Table Address Context - Surrogate Registration Count Statistics |
| Signaling, media, and control for a zone in the address context. |
| The Zone Statistics Current table. |
| The Zone Statistics Interval table. |
| The current status for zones in this address context. |
Beep Tone Inserted | Indicates whether beep tone is played during the call. Value is "yes/no". |
Command Examples
show table addressContext default ipAccessControlList getAggrPolicers
> show table addressContext default ipAccessControlList getAggrPolicers POLPOLICINGZONEPOLICING BUCKET PACKETPACKET ID TYPEIDMODE SIZECREDIT RATEACCEPTDISCARDAGG POL NAME ---------------------------------------------------------------------------------------- 1ACL - DataPktRate50 pkt50000 pkt/s25760 2ACL - DataPktRate50 pkt1000 pkt/s 12360OAM 3ACL - PktRate50 pkt100 pkt/s0 0ICMP 65 ACL - PktRate50 pkt1000 pkt/s 29070 0OAM 66 ACL - PktRate50 pkt10000 pkt/s47447 0SFTP 67 ACL - PktRate50 pkt2500 pkt/s 214 0RBA 68 ACL - PktRate50 pkt100 pkt/s0 0ICMP 69 ACL - PktRate50 pkt20000 pkt/s0 0OPERATOR 70 Zone1 Bypass 0 00 0ZONE AGGREGATE 71 ACL - PktRate50 pkt750 pkt/s0 0IKE 72 Zone1000Bypass 0 0870ZONE AGGREGATE 73 Zone1001Bypass 0 0890ZONE AGGREGATE
show table addressContext default staticRoute
> show table addressContext default staticRoute IP INTERFACEIP DESTINATION GROUPINTERFACE IP ADDRESS PREFIXNEXT HOP NAME NAMEPREFERENCE --------------------------------------------------------------------- 10.54.36.583210.54.154.1IF1pkt_a_v4v6100 10.54.36.803210.54.155.1IF2pkt_b_v4v6100
show table addressContext default sipGeneratedSubscriptionStatus
> show table addressContext default sipGeneratedSubscriptionStatus REGISTRAREXT PACKAGEIP EXPIRATIONSUBSCRIPTIONDOMAIN ID NAME ADDRESSTIMESTATE NAME ---------------------------------------------------------- 516 REG-EVENT 0.0.0.03660activeegress.com
show table addressContext default sipSubscriptionCountStatistics
> show table addressContext default sipSubscriptionCountStatistics SIP SIP SIP SUBSCRIPTIONSUBSCRIPTIONSIP SUBSCRIPTIONSIP COUNT COUNT SUBSCRIPTIONCOUNT SUBSCRIPTION NAME ATTEMPTSSUCCESSFULCOUNT ACTIVEPENDING COUNT FAILED ----------------------------------------------------------------------------- entry5 4 1 0 1
show table addressContext addr_1 dnsGroup DNSGrp1 dnsServerStatistics
TCP TCPTOTAL TCP CONNECTIONCONNECTIONTCP TCP EDNS EDNSINDEXIP ADDRESS QUERIESTIMEOUTSERRORSREFERRALSCONNECTIONFAILEDSUCCESS CONNECTIONTORNDOWNFALLBACKSTATUS FAILURES-------------------------------------------------------------------------------------------------------------------------------------------------110.54.78.2020 0 00 0 0 0 0 supported0
show table addressContext default zone ZONE_EGRESS sipTrunkGroup TG_ING media appSpecificBandwidth
> show table addressContext default zone ZONE_EGRESS sipTrunkGroup TG_ING media appSpecificBandwidth appSpecificBandwidth enabled;
Overview
Content Tools