In this section:

Note

The following section is only applicable to the DSC 8000, the DSC SWe (on MA-RMS), the Signaling Platform 2000 (SP2000), and the virtual SP2000 (on MA-RMS).

Before you can proceed with any other provisioning, you must select the link combinations that you want to have on your system.

The following table provides the link capacity (link combination) options matrix for the AMC308: 

AMC308 Link Capabilities Matrix

 

Link Combination

TDMATM
Low-speed (LS)High-speed (Annex A)High-speed ATM
1040
2126¹00
36420
46404
5024
6007²

¹ Although the Web UI shows that you can provision up to 128 Low-speed Links, for this release, the SP2000 only supports 126 Low-speed Links.

² Although the Web UI shows that you can provision up to 8 High-speed ATM Links, for this release, the SP2000 only supports 7 High-speed ATM Links.

 

The following table provides the link capacity (link combination) options matrix for the AMC348.

AMC348 Link Capabilities Matrix

Link CombinationTDMATM
Low-Speed (LS)High-Speed (Annex A)High-Speed ATM
1126100
26420
3040
46404
5024
60072

1 Although the Web UI shows that you can provision up 128 Low-speed Links, the DSC 8000 only supports 126 Low-speed Links.

2 Although the Web UI shows that you can provision up 8 High-speed ATM Links, the DSC 8000 only supports 7 High-speed ATM Links.


The following table provides the link capacity (link combination) options matrix for the PCE382.

PCE382 Link Capabilities Matrix

Link CombinationTDMATM
Low-Speed (LS)High-Speed (Annex A)High-Speed ATM
1124100
26420
3040
46404
5024
60042

1 Although the Web UI shows that you can provision up 128 Low-speed Links, the DSC SWe (on MA-RMS) only supports 124 Low-speed Links.

2 Although the Web UI shows that you can provision up 8 High-speed ATM Links, the DSC SWe (on MA-RMS) only supports 4 High-speed ATM Links.

 

Refer to the following sections for more information about the various supported link types:

To select the required link type and capacity

  1. From the Main Menu, click the required I/O card on the Hardware image.

  2. Click the required card.

  3. Click Capacity Configuration.
      

      
  4. Using the Select Configuration drop-down list, select the required configuration.

  5. Click Continue
Tip

The respective I/O card must be restarted to apply link combination or Protocol Variant changes (see To restart an I/O card).

To restart an I/O card

  1. From the Main Menu, click Processes.

  2. Click System Start/Stop Commands.

  3. Click Slot Selection drop-down list and select the card on which you changed the link combination.

  4. Click the Reboot radio button.

  5. Click Continue.