You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

In this section:

This section describes 

Unable to show "metadata-from": No such page "_space_variables"
 hardware and software requirements and recommendations.

To install and configure 

Unable to show "metadata-from": No such page "_space_variables"
, make sure the Virtual Machine (VM) host meets the following recommended hardware, server platform and software requirements.


The recommended hardware and software settings are intended to ensure optimum stability and performance. If the recommended settings are not used, the

Unable to show "metadata-from": No such page "_space_variables"
may not behave as expected.

License Requirements

You must obtain and apply a valid

Unable to show "metadata-from": No such page "_space_variables"
 license in order to configure and use the 
Unable to show "metadata-from": No such page "_space_variables"
. See below:


Server Hardware Requirements

Server Hardware Requirements

Configuration Requirement
Processor2nd Generation Intel Core or Intel Xeon Processor (Sandy bridge or later)
RAMEach SBC SWe Lite instance requires from 1.5 GiB to 4 GiB of RAM depending on the configuration
Drive Space
Hard disk requirements are dependent upon the number of VMs hosted, the size of each VM at full size, and whether checkpoints will be enabled.
Architecture64-bit Intel processor
Host OS

Microsoft Windows Server 2012R2

Microsoft Windows Server 2016

Minimum Hyper-V hosting requirements are posted by Microsoft.

The SBC SWe Lite does not support execution within a Hyper-V cluster, as defined at technet.microsoft.com. Contact your

Unable to show "metadata-from": No such page "_space_variables"
sales representative if you have any questions.


BIOS Setting Recommendations

Unable to show "metadata-from": No such page "_space_variables"
recommends the following BIOS settings for optimum performance:

Recommended BIOS Settings for Optimum Performance

BIOS ParameterRecommended
Setting
Details
Intel VT-x (Virtualization Technology)EnabledFor hardware virtualization
Intel Hyper-ThreadingEnabled

BIOS settings and recommendations must not be changed once it is applied on the server.

Unable to show "metadata-from": No such page "_space_variables"
Recommendations for
Unable to show "metadata-from": No such page "_space_variables"

General Recommendations

  • Plan enough resources (RAM, CPU, NIC ports, hard disk, etc.) for all the virtual machines (VMs) to run on a server, including resources needed by Hyper-V itself.
  • Allocate each VM with only as much virtual hardware as that VM requires. Provisioning a VM with more resources than it requires can, in some cases, reduce the performance of that VM as well as other virtual machines sharing the same host.
  • Disconnect or disable any physical hardware devices (Floppy devices, Network interfaces, Storage controllers, Optical drives, USB controllers, etc.) under BIOS settings that you will not be using to free up interrupt/CPU resources.


VM Configuration Recommendations

SettingMinimum
vCPU1, 2, 4 and 10 supported
RAM

1.5 GiB to support 1 vCPU

2 GiB to support 2 vCPUs

3 GiB to support 4 vCPUs

4 GiB to support 10 vCPUs

vNIC

5

(Up to 3 may be disabled, if only a single vNIC is required for media. Note: One vNIC is mandatory for management.)

Virtual Hard Disk5 GiB

 


Additional Information

  • Minimal networking configuration requires the Management Network Interface and at least one Media Interface to be assigned.
  • Each SBC SWe Lite VM will use approximately 5 GiB of Virtual Hard Drive space. Drive size is predetermined by the imported image.


Refer to Downloading the SBC SWe Lite Package for On-Premises Deployment for software download instructions.

  • No labels