You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

The EdgeView Service Control Center (SCC) is in the EdgeView and can launch an 

Unable to show "metadata-from": No such page "_space_variables"
instance's UI in your internet browser, which allows you to configure, operate, and monitor the instance if the remote UI connection is currently active. For example, you can configure the EdgeView Agent (EVAgent) logging and view the current connection and remote UI status of the EdgeView connection.

Note

To enable this feature for the

Unable to show "metadata-from": No such page "_space_variables"
, you require the EdgeView 16.0.0 Release or later.

To enable the EdgeView SCC, you must configure the EdgeView IP address or FQDN and the EdgeView Management ID. With the EdgeView SCC enabled, the 

Unable to show "metadata-from": No such page "_space_variables"
sends a SIP signaling group (SG) status report and the most recent, highest severity alarm to the EdgeView. The SIP SG status report includes information about the SIP SG's unique ID, administrative status, and real-time status.

Note

If a timeout results in the runtime status not being retrieved, then the 

Unable to show "metadata-from": No such page "_space_variables"
reports the real-time status as Unknown.

Configure the 
Unable to show "metadata-from": No such page "_space_variables"
for EdgeView during Initial Setup

To configure the 

Unable to show "metadata-from": No such page "_space_variables"
for EdgeView SCC during your initial setup, refer to the Running Initial Setup on SBC SWe Lite procedure.

When you configure the Initial Ribbon SBC SWe Lite Setup screen, use the following table to configure the EdgeView panel.

EdgeView Parameters

ParameterDescription
EdgeView

Configure this field to enable or disable the EdgeView SCC.

  • No (default) - The EdgeView is disabled.
  • Yes - The EdgeView is enabled.
EdgeView Address

Configure this field with the IP address or FQDN of the EdgeView.

Note: This field applies only when the EdgeView field is set to Yes.

EdgeView Management ID

Configure this field with the Management ID of the EdgeView.

Note: This field applies only when the EdgeView field is set to Yes.

EdgeView in Initial Ribbon SBC SWe Lite Setup Screen - Enabled

  • No labels