Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: fixed some odd formatting
Panel
borderColorgreen
bgColortransparent
borderWidth2
Noprint

Back to Table of Contents

Additional sections:

Children Display

...

 

This section depicts the maximum number of sessions between two codec types on an SBC 5400 with one DSP20 card or one, two, three, or four DSP25 cards installed.

Info

DSP density values are approximate and intended for use as a general guide when estimating transcoding capabilities. The cells highlighted in yellow may be limited by bandwidth depending upon packet size.

One DSP20

for an 

Spacevars
0model5
using either one DSP20 or up to four DSP25 modules. Only one DSP20 can be used in an SBC 5400
Spacevars
0model5
, and it cannot be mixed with DSP25 cards in modules within the same chassis, and between Active and Standby servers.

Note

Enabling V.8 signal analysis will further reduce densities. See V.8 Signal Analysis Support for details.

One DSP25

An SBC 5400 can be configured with up to four DSP25 cards that is 0, 1, 2, 3, or 4 DSP25s.

...

The 

Spacevars
0model5
density details are provided on the following pages according to the media port configuration:

 

Div
stylepadding-left:2%;

Children Display
styleh5

 

 

 

Info

DSP density values are approximate and intended for use as a general guide when estimating transcoding capabilities.

 

Pagebreak