Windows and/or dialog boxes depicted in this section are intended as examples only and may not reflect the actual software/firmware versions applicable to you. Refer to any associated hardware/software requirements as well as the relevant release note for software/firmware version details.
The following procedure describes how to install the SBC 5400 application as an HA pair configuration:
Launch the EMA. Refer to Logging into EMA in Platform Mode for guidance.
Navigate to Administration > System Administration > Software Install/Upgrade tab. The Packages screen is displayed.
Select the Package Name to install.
Click Install Software.
The Install Software section expands and displays the Install Software, Management Ports (configured via the BMC) and System Configuration details.- Enter the System Configuration details.
- Select HA Pair in the HA Configuration field.
- Select System Name field and enter the system name.
- Select Local Hostname and enter local hostname.
Select Peer Hostname and enter peer hostname.
- Choose the Active option for Server Role to designate the Active server.
For SBC hardware type of installation, choose SBC Type as I-SBC.
For SBC Type, choose from the options listed:SBC Type Description I-SBC Specifies an Integrated Signaling and Media network element (I-SBC). This is applicable for SBC on hardware environment (SBC 7000 Series, and SBC 5400). S-SBC Specifies the SBC type as Signaling. The S-SBC (Signaling SBC) is applicable for SBC on Cloud environment. M-SBC Specifies SBC type as Media. The M-SBC (Media SBC) is applicable for SBCona cloud environment. - Select NTP Server IP field and enter the NTP server IP address. To identify your NTP Server IP, refer to Configuring SBC 5400 NTP Server Settings.
- Select NTP Server Time Zone field and enter the time zone.
Click Start Installation.
The installation process begins and displays the installation status on the Installation Log section.
The following actions are performed during the installation process:Pre-Installation Checks
Package content extraction:
Install SBC 5400 service.
Initialize SBC 5400 service and update the SBC 5400 host name.
Reboot SBC 5400 system.
Log on to EMA. The new SBC application version is displayed on the Monitoring > Dashboard > System and Software Info window.
Verify the system status using Administration > System Administration > Platform Management menu.
- From the EMA, install the SBC licenses required in order to use SBC application and its features. See Node-Locked Licensing for guidance.
Repeat steps 2 through 9 to install the SBC application on the Standby peer, but with the following changes to steps 5c, 5d, and 5e:
Step 5c. Enter Standby server name in Local Hostname field, which is typically the System Name with a letter “b” appended at the end.
Step 5d. Enter Active server name for Peer Hostname field, which is typically the System Name with a letter “a” appended at the end.
Step 5e. Choose Standby option for Server Role to designate the Standby server as the one you are configuring.
Click Start Installation.
Once the installation is completed, verify the system status for both "Active" and "Standby" servers using Monitoring > Dashboard > System and Software Info menu.
After the installation is complete on both the servers, verify the sync status using the
show table system syncStatus
CLI command:admin@XXXX> show table system syncStatus SYNC MODULE STATUS --------------------------------------- Policy Data syncCompleted Disk Mirroring syncCompleted Configuration Data syncCompleted Call/Registration Data syncCompleted
Status for all sync modules should besyncCompleted
.