In this section:
The SBC Core platform supports inter-working between Diversion header and History-Info header based on RFC 6044. In addition to handling the History-Info header in SIP messages in the dotted notation of indexes, the SBC supports the Cause parameter as specified in RFC 4458 or Reason header as specified in RFC 4244.
The IP Signaling Profile flag, "Diversion History Info Interworking", indicates to the egress side that the inter-working is accomplished as per the RFC 6044. In addition, the existing Redirecting Info flag of "Diversion" and "History-Info" will indicate to the egress the target inter-working header which needs to be sent out in INVITE message. The Diversion and History-Info headers received on the ingress side are transparently passed across to the egress where newly introduced flags determine the corresponding header to be used to pass on this information in outgoing INVITE.
This feature is supported across GW-GW, where the SBC is the egress node.
When a 3xx response is received with both Diversion and History-Info header, Diversion header processing is given priority within the received 3xx, irrespective of the Diversion or History-Info configuration on the new egress route where the call is redirected.
IMPORTANT
Ribbon recommends using the Transparency Profile to configure transparency on the SBC Core for new deployments, as well as applying additional transparency configurations to existing deployments. Do not use IP Signaling Profile flags in these scenarios because the flags will be retired in upcoming releases.
Refer to the SBC SIP Transparency Implementation Guide for additional information.
To View and Edit Call Forwarding
On the SBC main screen, go to Configuration > System Provisioning > Category: Trunk Provisioning > Ip Signaling Profile > Egress Ip Attributes > Sip Headers And Parameters > Call Forwarding. The Call Forwarding window is displayed.
DEFAULT_H323
On the Call Forwarding window, choose the Ip Signaling Profile as DEFAULT_H323 to view the Call Forwarding for H323 Trunk Group.
Trunk Provisioning - Egress Ip Attributes H323 Call Forwarding
There are no Call Forwarding parameters for DEFAULT_H323 type of Egress Ip Attributes.
DEFAULT_SIP
On the Call Forwarding window, choose the Ip Signaling Profile as DEFAULT_SIP to view the Call Forwarding for SIP Trunk Group.
Trunk Provisioning - Egress Ip Attributes SIP Call Forwarding
Call Forwarding Parameters
Parameter | Description |
|---|---|
| Diversion History Info Interworking | Enable flag to allow interworking between Diversion and History-Info header as per RFC 6044. The SBC supports up to 12 History-Info entries and 10 Diversion entries. When this flag is disabled, only the first and last entries are maintained when History-Info or diversion transparency is disabled.
NOTE: This flag is only visible when either Diversion or History-Info header is selected as the egress call-forwarding header. Diversion and History-Info Transparency configuration controls are ignored when it is enabled. This parameter has precedence over these controls, as well as the TG Signaling flag acceptHistoryInfo. |
| Data Mapping | Use this parameter to define how to map the diversion or redirecting data. Options are:
|
| Diversion Header Transparency | When enabled, the ingress Diversion header is passed through unchanged. Call forwarding data mapping transparency applies to Diversion header only.
|
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.
Overview
Content Tools