This section specifies the Overlap dialing parameters.

To View and Edit Overlap Dialing

On SBC main screen, go to Configuration > System Provisioning > Category: Trunk Provisioning > Trunk Group > H323Trunk Group > H323 Trunk Advanced > H323 Trunk - Services - Advanced > Overlap Dialing. The Overlap Dialing window is displayed.

The Overlap Dialing can be checked for each Address Context, for each Zone, for each H323Trunk Group created or for all the Address Contexts, Zones and H323Trunk Groups created. Use the drop-down box to select the desired Address Context, Zone and H323Trunk Group.

The Edit Overlap Dialing window is displayed.

H323 Trunk Advanced - H323 Trunk - Services - Advanced - Overlap Dialing

 

The following fields are displayed:

H323 Trunk Advanced - Overlap Dialing Parameters


Parameter


Description

Overlap StateControl to determine if Overlap Dialing is supported.
  • disabled (default)
  • egressOnly – Select to enable egress overlap dialing only for a trunk group +both egress and ingress.
  • enabled – Select to enable overlap dialing. If the trunk group is being used for both ingress and egress, then both directions are enabled.
  • ingressOnly – Select to enable ingress overlap dialing only for a trunk group using both egress and ingress.
Min Digits For QueryControls the number of called address digits to collect before performing the first policy query during overlap receiving. If set to “0”, this parameter is irrelevant in controlling policy query. (Range: 0-30 / default = 0)

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

 

  • No labels