In this section:
Easy Configuration Wizard for End to End Configuration
The
The wizard produces different configuration options depending on the desired deployment.
The following configuration options are available for SBC 1000/2000 and
- SIP Trunk ↔ Microsoft on Premises
- SIP Trunk ↔ ISDN PBX
- SIP Trunk ↔ IP Phones
- SIP Trunk ↔ IP PBX
- ISDN PSTN ↔ Microsoft on Premises
- FXO ↔ Microsoft on Premises (available for Unable to show "metadata-from": No such page "_space_variables"and FXO Analog only)
- SIP Trunk ↔ Microsoft Teams
- ISDN PSTN ↔ Microsoft Teams
- IP PBX ↔ Microsoft Teams
The following configuration options are available for
Easy Configuration for Single Leg Endpoint Configuration
The
Emergency configuration is not supported for single end scenarios.
The following configuration options are available for SBC 1000/2000 and
- Single Leg Endpoint for IP PBX
- Single Leg Endpoint for IP Phones
- Single Leg Endpoint for Microsoft On Premises
- Single Leg Endpoint for Microsoft Teams
- Single Leg Endpoint for SIP Trunk
- Single Leg Endpoint for FXO
- Single Leg Endpoint for ISDN/PSTN
The following configuration options are available for
- Single Leg Endpoint for SIP Trunk
- Single Leg Endpoint for Microsoft Teams
- Single Leg Endpoint for IP PBX
Using the Easy Configuration Wizard
If the Easy Configuration Wizard is run a second time, it will always create new configuration elements for the scenario being set up. Updates will not be made to the previous configured items.
The Easy Configuration Wizard is available through the following two methods:
Run using Initial Setup
Access the Easy Configuration wizard during during Initial Setup:
- Configure the desired fields. See Running Initial Setup on SBC SWe Edge, Ribbon SBC 2000 - Initial Setup or Ribbon SBC 1000 - Initial Setup.
- From the Easy Setup drop down list, select Launch on First Login.
- Click Apply. The Easy Configuration Wizard is presented after login for immediate configuration.
- Select the desired template and configure. See Working with SBC Easy Configuration.
Run using the Easy Configuration Wizard
If the Easy Configuration wizard is not enabled or configured during the Initial Setup (Running Initial Setup on SBC SWe Edge, Ribbon SBC 2000 - Initial Setup or Ribbon SBC 1000 - Initial Setup) process, it can be accessed through the WebUI Task tab.
Access the Easy Configuration wizard:
- In the WebUI, click the Tasks tab.
- In the left navigation pane, go to SBC Easy Setup > Easy Config Wizard. The Easy Configuration screens open.
- Select the desired template and configure. See Working with SBC Easy Configuration.