The SBC Quality of Experience (QoE) feature collects data about call RTP streams, generates MOS information, and sends them to a QoE server.
For more information about RTCP and MOS see the following:
To enable and configure the QoE service:
In the left navigation pane, go to System > QoE.
In the example below, IPv6 is configured.
QOE Service
Specifies whether the node is a QoE client or the QoE server.
The IP address of the QoE server node receiving the SIP NOTIFY message. QoE Reporting must be enabled in the SIP Signaling Group.
Both IPv4 and IPv6 addresses are supported.
The IP address of the QoE server node receiving the SIP NOTIFY message. QoE Reporting must be enabled in the SIP Signaling Group.
Specifies the transport protocol used to send the NOTIFY.
If TLS is selected this specifies the TLS Profile this port will use for secure SIP messages.