In this section:
This section describes SBC SWe Lite hardware and software requirements and recommendations.
To install and configure SBC SWe Lite, make sure the Virtual Machine (VM) host meets the following recommended hardware, server platform and software requirements.
License Requirements
You must obtain and apply a valid SBC SWe Lite license in order to configure and use the SBC SWe Lite. See below:
- If you are deploying an SBC SWe Lite trial instance (as described at SBC SWe Lite Trial Offer for On-Premises Deployment ) please refer to Obtaining and Installing a SWe Lite Trial License for license instructions;
- If you are not deploying a trial instance, please follow license instructions posted at Obtaining and Installing an SBC SWe Lite Production License.
Server Hardware Requirements
Microsoft Windows Server 2012R2 Microsoft Windows Server 2016 Minimum Hyper-V hosting requirements are posted by Microsoft. The SBC SWe Lite does not support execution within a Hyper-V cluster, as defined at technet.microsoft.com. Contact your Ribbon sales representative if you have any questions.Configuration Requirement Processor 2nd Generation Intel Core or Intel Xeon Processor (Sandy bridge or later) RAM Each SBC SWe Lite instance requires from 1.5 GiB to 4 GiB of RAM depending on the configuration Drive Space Hard disk requirements are dependent upon the number of VMs hosted, the size of each VM at full size, and whether checkpoints will be enabled. Architecture 64-bit Intel processor Host OS
BIOS Setting Recommendations
Ribbon recommends the following BIOS settings for optimum performance:
Recommended BIOS Settings for Optimum Performance
| BIOS Parameter | Recommended Setting | Details |
|---|---|---|
| Intel VT-x (Virtualization Technology) | Enabled | For hardware virtualization |
| Intel Hyper-Threading | Enabled |
Ribbon Recommendations for SBC SWe Lite
General Recommendations
- Plan enough resources (RAM, CPU, NIC ports, hard disk, etc.) for all the virtual machines (VMs) to run on a server, including resources needed by Hyper-V itself.
- Allocate each VM with only as much virtual hardware as that VM requires. Provisioning a VM with more resources than it requires can, in some cases, reduce the performance of that VM as well as other virtual machines sharing the same host.
Disconnect or disable any physical hardware devices (Floppy devices, Network interfaces, Storage controllers, Optical drives, USB controllers, etc.) under BIOS settings that you will not be using to free up interrupt/CPU resources.
VM Configuration Recommendations
| Setting | Minimum |
|---|---|
| vCPU | 1, 2, 4 and 10 supported |
| RAM | 1.5 GiB to support 1 vCPU 2 GiB to support 2 vCPUs 3 GiB to support 4 vCPUs 4 GiB to support 10 vCPUs |
| vNIC | 2 SBC SWE Lite is created with 5 Virtual Network Interfaces (vNIC); up to 3 interfaces may be disabled. Note: One vNIC is mandatory for management. |
| Virtual Hard Disk | 5 GiB |
Additional Information
- Minimal networking configuration requires the Management Network Interface and at least one Media Interface to be assigned.
- Each SBC SWe Lite VM will use approximately 5 GiB of Virtual Hard Drive space. Drive size is predetermined by the imported image.
Overview
Content Tools