Note

Applicable only for CALEA users.

Overview

This section outlines the commands to configure the Default LI on the M-SBC. For more information about the Default LI configuration, refer to Default LI Configuration.

Note
  • As a prerequisite to configure the Default LI on the M-SBC, ensure that the Call Data Channel (CDC) is enabled and running.
  • You can configure the Default LI with only the default address context.
  • For more information on the parameters and their descriptions, refer to Intercept - CLI.

Configuring the Default LI in the M-SBC

Use the following command to establish the LI CDC configuration in the M-SBC.

% set addressContext default intercept callDataChannel <callDataChannel_name>
   interceptStandard <packetcable | packetcablePlusEtsi>
   vendorId <none | utimaco | verint>
% commit 
Note

For the Default/Legacy LI, the M-SBC does not have an ipInterfaceGroup parameter in the CDC configuration to send the intercepted media. The configuration of the ipInterfaceGroup parameter in the S-SBC CDC determines which LIF group the M-SBC uses for intercepted media, which means the M-SBC is configured with the LIF group that the S-SBC uses.