The
Unable to show "metadata-from": No such page "_space_variables"
can be managed remotely by an SNMP network management system.Note
If you are using
Unable to show "metadata-from": No such page "_space_variables"
Service Control Center (Unable to show "metadata-from": No such page "_space_variables"
SCC), and SNMP polling is enabled, SNMP v1 must be enabled, and the community must be identical on both ends.The following figure shows an example of the
Unable to show "metadata-from": No such page "_space_variables"
configured for an SNMP Network.SNMP Configuration Example
The following table lists SNMP management support.
SNMP Support
| Item | Description |
|---|---|
SNMP | Unable to show "metadata-from": No such page "_space_variables" SNMP version support.SNMPv1—Can be configured by itself or with SNMPv3. Supports multiple SNMPv1 and SNMPv2 trap destination configurations. Traps are sent to each configured destination using the appropriate protocol version and community string. Refer to Configuring SNMPv1. SNMPv2—Supported as part of SNMPv1. Choose Show Trap Destinations > Add a Trap Destination and enter “2” in the Version field to tell the Unable to show "metadata-from": No such page "_space_variables" to send a message to every remote host in the list when errors are present. Refer to Configuring SNMPv1.SNMPv3—Supports password-protected security. Can be configured by itself or with SNMPv1. Supports only one trap destination. Refer to Configuring SNMPv3. |
MIBS | Unable to show "metadata-from": No such page "_space_variables" read-only MIB support.
|
Traps | Unable to show "metadata-from": No such page "_space_variables" trap support:
|
Overview
Content Tools