You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Current »

This article describes the steps necessary to configure the 

Unable to show "metadata-from": No such page "_space_variables"
with a SIP peer or with an Internet Telephony Service Provider (ITSP) that requires digest authentication with 401 Unauthorized challenge.

In this section:

Related Articles:

Prerequisites

General

This document assumes that you have already created a Signaling Group and a SIP Server table for the ITSP.

Software Version

Verify that your

Unable to show "metadata-from": No such page "_space_variables"
is loaded with the correct boot image version and that your SBC Edge base software version is at least version 2.0.0, build 108.

System Licenses

The

Unable to show "metadata-from": No such page "_space_variables"
system must have the necessary licenses to make calls.

Configuration Steps

The configuration is comprised of three overall steps:

  • Creating a Remote Authorization Table
  • Assigning the Remote Authorization Table to the SIP Server Table
  • Assigning the SIP Server Table to the Signaling Group for the ITSP

  1. Add a Remote Authorization Table.

  2. Add a Remote Authorization entry.

  3. Assign the Remote Authorization Table to the SIP Server Table.

Additional Information

Call Flow

The call flow below depicts an outbound call from Skype to ITSP via

Unable to show "metadata-from": No such page "_space_variables"
SBC 1000/2000.

  • After the initial INVITE from the Mediation server, 
    Unable to show "metadata-from": No such page "_space_variables"
    (UA) sends an INVITE request to the ITSP proxy server (UAS).
  • Unable to show "metadata-from": No such page "_space_variables"
     then receives 100 Trying and then 401 Unauthorized request from the ITSP proxy server.
  • Unable to show "metadata-from": No such page "_space_variables"
    , acting as a UA, then re-sends the request and authenticates itself by including an Authorization header field with the request.
  • The Authorization field value consists of credentials containing the authentication information of the UA for the realm of the resource being requested as well as parameters required in support of authentication and replay protection.
  • The Realm, Username and Password information are taken from the Remote Authorization Table entry based on the username that is provided by the realm provided by the UAS.

Call Flow

Call Debugging Trace

The 

Unable to show "metadata-from": No such page "_space_variables"
debug log produced at Trace level will show the information that is used to compute the MD5 string used in the Authorization header:

Example
[2012-04-12 16:17:40,303] 5688 0001 com.net.ux.sip TRACE (Credentials.cpp:451) - computeResponse: creating credentials:
   algorithm : "MD5"
   userName  : "d8Er27ScWIQ"
   passWord  : "1234567ZZzzZ"
   realm     : "ITSPRealm"
   nonce     : "ITSPRealmDe98wSj8euJdU8SHs8"
   cNonce    : "baea32a3"
   nonceCount: "00000001"
   qop       : "auth"
   method    : "INVITE"
   uri       : "sip:15105742474@10.0.0.10:5070;user=phone"

  • No labels