Not applicable to SBC SWe Edge.
This section describes how to configure the DS1 port types (T1/E1) on the
SBC 2000 T1/E1 Ports
T1/E1 ports on the SBC 2000 are provided via removable T1/E1 PSTN Interface cards. The SBC 2000 supports up to two T1/E1 PSTN Interface cards with a maximum of 16 physical T1/E1 ports. The T1/E1 PSTN Interface cards are available with 8 T1/E1 ports licensed individually. Each SBC 2000 T1/E1 PSTN Interface Card provides two four-port spans, each span is individually configurable as either T1 or E1.
SBC 1000 T1/E1 Ports
T1/E1 ports on the SBC 1000 are provided via two non-removable module cards (each card provides two ports; each port is licensed individually).
Two T1/E1 Ports on the SBC 1000 are available only if running SBC 1000 v2 hardware and SBC Release 6.0.0 or later; previous releases support one T1/E1 port only.
Setting the Port Type
To set the port type:
Click the Set DS1 Port Type text at the top of the Port Table View page.
DS1 Port Types - SBC 2000
DS1 Port Types - SBC 1000- Select either T1 or E1 from the ports menu(s).
- Click OK.