DO NOT SHARE THESE DOCS WITH CUSTOMERS!
This is an LA release that will only be provided to a select number of PLM-sanctioned customers (PDFs only). Contact PLM for details.
In this section:
This section describes
Unable to show "metadata-from": No such page "_space_variables"
hardware and software requirements and recommendations for VMware.To install and configure
Unable to show "metadata-from": No such page "_space_variables"
, make sure the Virtual Machine (VM) host meets the following recommended hardware, server platform and software requirements.Warning
The recommended hardware and software settings are intended to ensure optimum
Unable to show "metadata-from": No such page "_space_variables"
stability and performance. If the recommended settings are not used, the Unable to show "metadata-from": No such page "_space_variables"
system may not behave as expected.Warning
Using older versions of ESXi can trigger a VM instance shutdown. To prevent this from occurring, you must upgrade the VMware ESXi -- refer to the End of General Support column on https://lifecycle.vmware.com/#/ for supported versions.
SBC SWe for VMware – Server Hardware Requirements
The following table lists the server hardware requirements: Intel Xeon processors (Nehalem micro-architecture or above) with 6 cores and above (processors should support hyper threading). Ribbon recommends using Westmere (or newer) processors for better SRTP performance. These processors have the AES-NI instruction set for performing cryptographic operations in hardware. The supported CPU Family number is 6 and CPU Model number must be newer than 26. Refer to the Intel Architecture and Processor Identification document for more information. ESXi 6.5 and later releases require approximately 2 physical cores to be set aside for hypervisor functionality. The number of VMs which can be hosted on a server must be planned for accordingly. Make sure NICs have multi-queue support which enhances network performance by allowing RX and TX queues to scale with the number of CPUs on multi-processor systems. The following NICs are supported for configuring as SR-IOV and DirectPath I/O pass-through devices. SR-IOV is supported only with 10 Gbps interfaces (x540/82599/x710): The VMware Enterprise Plus license is required for SR-IOV. Number of ports allowed: The Configuration Requirement Processor
Note
Note
Note
RAM Minimum 24 GB Hard Disk Minimum 500 GB Network Interface Cards (NICs) Minimum 4 NICs, if physical NIC redundancy is not required.
Note
Note
Ports
Warning
Unable to show "metadata-from": No such page "_space_variables" software only runs on platforms using Intel processors. Platforms using AMD processors are not supported.
SBC SWe for VMware – Software Requirements
The following are the * The version must be supported. See the End of General Support column at https://lifecycle.vmware.com/#/ for supported versions. The VMware Enterprise Plus license is required for SR-IOV.Unable to show "metadata-from": No such page "_space_variables" requirements for VMware ESXi environments:Software Version* Tested and Qualified Version For More Information vSphere ESXi 6.0 or above vSphere Client 5.1 or above VMware Knowledge Base vCenter Server 5.1 or above vCenter Server
Note
Third-Party References:
- Refer to the VMware Compatibility Guide (external site) for a list of VMware-supported Intel processors.
- Refer to ESXi hardware requirements to ensure the VMware-supported Intel processor meets the ESXi hardware requirements.
Overview
Content Tools