You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »


In this section:

Related articles:

This section describes

Unable to show "metadata-from": No such page "_space_variables"
hardware and software requirements and recommendations.

To install and configure

Unable to show "metadata-from": No such page "_space_variables"
, make sure the Virtual Machine (VM) host meets the following recommended hardware, server platform and software requirements.

Warning

The recommended hardware and software settings are intended to ensure optimum 

Unable to show "metadata-from": No such page "_space_variables"
stability and performance. If the recommended settings are not used, the
Unable to show "metadata-from": No such page "_space_variables"
system may not behave as expected.

SBC SWe for VMware – Server Hardware Requirements


The following table lists the server hardware requirements:

Server Hardware Requirements


 ConfigurationRequirement
Processor

Intel Xeon processors (Nehalem micro-architecture or above) with 6 cores and above (processors should support hyper threading).

Note

Ribbon recommends using Westmere (or newer) processors for better SRTP performance. These processors have the AES-NI instruction set for performing cryptographic operations in hardware.

Note

The supported CPU Family number is 6 and CPU Model number must be newer than 26. Refer to the Intel Architecture and Processor Identification document for more information.

Note

ESXi 6.5 and later releases require approximately 2 physical cores to be set aside for hypervisor functionality. The number of VMs which can be hosted on a server must be planned for accordingly.

 RAMMinimum 24 GB
Hard DiskMinimum 500 GB
Network Interface Cards (NICs)
Minimum 4 NICs, if physical NIC redundancy is not required.
Note

Make sure NICs have multi-queue support which enhances network performance by allowing RX and TX queues to scale with the number of CPUs on multi-processor systems.

Note
  • The following NICs are supported for configuring as SR-IOV and DirectPath I/O pass-through devices. SR-IOV is supported only with 10 Gbps interfaces (x540/82599/x710):

Intel I350, x540, x550, x710 and 82599, Mellanox Connect - 4x, Mellanox Connect - 5x, and CISCO VIC. 

  • The VMware Enterprise Plus license is required for SR-IOV.
Ports

Number of ports allowed:



Warning

The 

Unable to show "metadata-from": No such page "_space_variables"
software only runs on platforms using Intel processors. Platforms using AMD processors are not supported.



SBC SWe for VMware – Software Requirements

The following are the

Unable to show "metadata-from": No such page "_space_variables"
 requirements for VMware ESXi environments:

VMware ESXi Requirements

VMWare ESXi Requirements

SoftwareVersionTested and Qualified VersionFor More Information
vSphere ESXi 6.0 or above
  • VMware 6.0 tested with VM version 11
  • VMware 6.5 tested with VM version 13
  • Customized ESXi images for various server platforms are available on VMware and hardware platform vendor sites.
    • These ensure that all the required drivers for network and storage controllers are available to run ESXi server.
    • Most of the customized ESXi images come with customized management software to manage the server running the ESXi software.
    • Customized ESXi images for HP ProLiant and IBM servers are available at:
vSphere Client5.1 or above
VMware Knowledge Base
vCenter Server5.1 or above
vCenter Server
Note

The VMware Enterprise Plus license is required for SR-IOV.

Third-Party References:


  • No labels