EdgeMarc 7300/7301 Back Panel

EdgeMarc 7300/7301 Back Panel Components


Physical Label/TypeFunctionDescription
1

Port 1

LAN 1

10/100/1000 Mbps RJ-45 Ethernet port for LAN network connectivity.

Default IP: 192.168.1.1

2

Port 2

WAN 1

10/100/1000 Mbps RJ-45 Ethernet port for connectivity to the WAN or Internet network connectivity.

Default IP: None

3

Port 3

Mgmt

10/100/1000 Mbps RJ-45 Ethernet port for optional management network connectivity. This interface must not be on the same network as the WAN or LAN subnets. This network cannot be within a subnet contained in a “Route” statement.

4

Port 4

WAN 2

Secondary WAN Interface Port. 10/100/1000 Mbps RJ-45 Ethernet port for connectivity to the WAN or Internet network connectivity.

The port is covered with a removable RJ-45 cap. Remove the cap before use.

Supports basic routing in addition to the following:

•  Dual WAN Port feature—Two discrete WAN interfaces with the ability to independently route

•  WAN failover / WAN Link Redundancy (WLR)

•  Link aggregation for WAN acceleration

Note: This port is unused if you are running a software release prior to 13.11.2.

5

Port 5

LAN 2

10/100/1000 Mbps RJ-45 Ethernet port for LAN network connectivity.

Default IP: 192.168.1.1.

The port is covered with a removable RJ-45 cap. Remove the cap before use.

Note: This port is unused if you are running a software release prior to 13.12.

6

Port 6

LAN 3

10/100/1000 Mbps RJ-45 Ethernet port for LAN network connectivity.

Default IP: 192.168.1.1.

The port is covered with a removable RJ-45 cap. Remove the cap before use.

Note: This port is unused if you are running a software release prior to 13.12.

7

Erase

Erase button

Press the Erase button in quick succession to control the following:

  • One click—No action.
  • Two clicks—Resets the CLI password to what is stored in the manufacturing configuration.

  • Three clicks—Restores to factory default settings and reboots the system.

    Note

    When restored to factory default settings, the current configuration is lost, disconnecting all VoIP devices, Internet connectivity, and network access for computers until the system is reconfigured.

    Note

     If the Erase button is disabled (as noted on the Admin page of the GUI) and you wish to reset the password, please contact the Global Support Assistance Center:

    Ribbon Support Portal:  https://ribboncommunications.com/services/ribbon-support-portal-login.

    Voice: +1-833-RIBBON1 (1-833-742-2661)

8

VGA Port

Unused

Reserved for future use.

9

RJ-45 Port

Serial

Craft

Console

Port

RJ-45 serial craft console port for management.

Baud: 9600

Data: 8

Parity: N

Stop: 1

Flow Control: NONE

An RJ-45 to DB9 console cable is included in the box with the EdgeMarc 7300/7301.

10

3-prong male power port

Input

Power Socket

Accepts a 3-pin shroud female plug for input power.

11

On/Off Switch

System power switch

Powers the system on and off.

12

USB Ports

Unused

Reserved for future use.