You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Back to Table of Contents

Back to Configuration

Back to Configuration - Profile Management

Back to Profile Management - Security Profiles

Additional section:

In this section:

This object configures IKE Protection Profile by establishing the encryption algorithm, the maximum SA lifetime, and other SA conditions, for the peer. These properties are linked to each IKE peer that is provisioned with this profile.

To View Ike Protection Profile

On SBC main screen, go to Configuration > Profile Management > Category: Security Profiles > Ike Protection Profile.

The Ike Protection Profile window is displayed.

Profile Management - Security Profiles - Ike Protection Profile

To Edit Ike Protection Profile

To edit any of the Ike Protection Profile in the list, click the radio button next to the specific Ike Protection Profile name.

Profile Management - Security Profiles - Ike Protection Profile Highlighted

The Edit Selected Ike Protection Profile window is displayed below.

Profile Management - Security Profiles - Ike Protection Profile Edit Window

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

To Create Ike Protection Profile

To create a new Ike Protection Profile, click New Ike Protection Profile tab on the Ike Protection Profile List panel.

Profile Management - Security Profiles - Ike Protection Profile Fields

The Create New Ike Protection Profile window is displayed.

Profile Management - Security Profiles - Ike Protection Profile Create Window

The following fields are displayed:

IKE Protection Profile Parameters

Parameter

Description

Name

The name of the IKE Protection Profile.

SA Lifetime
Time

The SA Lifetime setting, in seconds. This is the maximum interval that any one  Security Association will be maintained before possible re-keying. Must be 1200-
1,000,000, default is 28,800 (seconds).This parameter applies to the IKE SA when it  appears in the IKE Protection Profile and to the IPsec SA when it appears in the IPsec Protection Profile.

The default value corresponds to 8 hours

DPD Interval

Specifies the IKE Protection Profile Dead Peer Detection test interval period in seconds. The value '0' corresponds to DPD disabled.

Pfs Required

Enable flag to require PFS use during IPSec SA negotiation.

  • disabled (default)
  • enabled

To Copy Ike Protection Profile

To copy any of the created Ike Protection Profile and to make any minor changes, click the radio button next to the specific Ike Protection Profile to highlight the row.

Profile Management - Security Profiles - Ike Protection Profile Highlighted

Click Copy Ike Protection Profile tab on the Ike Protection Profile List panel.

Profile Management - Security Profiles - Ike Protection Profile Fields

The Copy Selected Ike Protection Profile window is displayed along with the field details which can be edited.

Profile Management - Security Profiles - Ike Protection Profile Copy Window

Make the required changes to the required fields and click Save to save the changes. The copied Ike Protection Profile is displayed at the bottom of the original Ike Protection Profile in the Ike Protection Profile List panel.

To Delete Ike Protection Profile

To delete any of the created Ike Protection Profile, click the radio button next to the specific Ike Protection Profile which you want to delete.

Profile Management - Security Profiles - Ike Protection Profile Highlighted

Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.

Profile Management - Security Profiles - Ike Protection Profile Delete Confirmation

Click Yes to remove the specific Ike Protection Profile from the list.

  • No labels