In this section:
This object allows you to configure signaling ports for gateway-to-gateway call signaling.
GW signaling port limitations:
- Create the GW signaling port under the default address context and within the 'defaultSigZone'.
- GW signaling port must use an ID of "1".
Note
Each signaling port within an Address Context must use a unique IP address and port number combination.
Note
The SBC 52x0 and SBC 7000 systems support creating IP Interface Groups containing sets of IP interfaces that are not "processor friendly" (i.e. carried on physical Ethernet ports served by separate processors). However, restrictions exist regarding the usage of such Interface Groups.
(This ability does not apply to the SBC 51x0 and SBC 5400 systems which have only two physical media ports. IP interfaces from the two physical ports may be configured within the same IP Interface Groups without restriction.)
For complete details, refer to Configuring IP Interface Groups and Interfaces.
To View Gw Sig Port
On SBC main screen, go to Configuration > System Provisioning > Category: Base Provisioning > Signaling Ports > Gw Sig Port. The Gw Sig Port window is displayed.
Signaling Ports - Gw Sig Port
The Gw Sig Port can be checked for each Address Context or for each Zone or for all the Address Contexts and Zones created. Use the drop-down box to select the desired Address Context and Zone.
Gw Sig Port Main Field
To Edit Gw Sig Port
To edit any of the Gw Sig Ports in the list, click the radio button next to the specific Gw Sig Port name.
Gw Sig Port Highlighted
The Edit Selected Gw Sig Port window is displayed below.
Gw Sig Port Edit Window
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.
To Create Gw Sig Port
To create a new Gw Sig Port, click New Gw sig Port tab on the Gw Sig Port List panel.
Gw Sig Port Fields
The Create New Gw Sig Port window is displayed.
Gw Sig Port Create Window
The following fields are displayed:
Gw Sig Port Parameters
Parameter | Description |
|---|---|
| Specify the index for gateway signaling port. |
| The name of the IP interface group used by this Signaling Port. |
| Specifies the IP Address of the Gateway Signal Listen Port. This is V4 and V6 IP |
| The logical port number of the TCP port to use for this connection. Must be 1-65535, default is 2569. |
| The main role of the signaling port: Unable to show "metadata-from": No such page "_space_variables" , using its IP address as the local address for listening. • secondary—an alternate port that is used for listening only and cannot be used to establish new gateway signal links. When no primary port exists, connection requests to other Unable to show "metadata-from": No such page "_space_variables" cannot be issued and calls which require them are disconnected. When a secondary port is configured to be primary, the previous primary is automatically made secondary. |
| The operational state of the Gateway signaling service: Unable to show "metadata-from": No such page "_space_variables" . |
| The administrative state of this gateway signaling port: |
To Delete Gw Sig Port
To delete any of the created Gw Sig Port, click the radio button next to the specific Gw Sig Port which you want to delete.
Gw Sig Port Highlighted
Click Delete at the end of the highlighted row. A delete confirmation message appears seeking your decision.
Gw Sig Port Delete Confirmation
Click OK to remove the specific Gw Sig Port from the list.
Overview
Content Tools