You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 2 Next »

Back to CLI Configure Mode

Back to Address Context - CLI

Back to Zone - CLI

Back to Zone - SIP Trunk Group - CLI

 

Use this object to define ingress IP prefixes. Up to 128 ingressIpPrefix entries may be assigned to a SIP trunk group. Ingress peers matching these ingress IP prefixes are assigned to the specified SIP trunk group.

As a best practice, always use UPPERCASE for trunk group names.

Command Syntax

% set addressContext <name> zone <name> sipTrunkGroup <name> ingressIpPrefix <IP address + prefix>

Command Parameters

SIP Trunk Group Ingress IP Prefix Parameters

ParameterLength/RangeDescription
ingressIpPrefixN/AThe ingress peers matching this ingress IP and prefix will be assigned to this SIP trunk group. Enter IPv4 or IPv6 address in the following format:
  • IPv4 – Specifies the V4 IP address in dotted decimal form (for example 10.11.12.0 24).
  • IPv6 – The V6 IP address in hexadecimal/colon form (for example, fd00:21:445:128::7880 64).
  • prefixLength – The number of bits in the address which form the network part of the IP address. The remaining bits (128 – prefix length) specify the host part of the IP address. (range: 0-128).
  • No labels