You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

Back to Table of Contents

Back to Configuration

Back to Configuration - Profile Management

Back to Profile Management - Media Profiles

Back to Media Profiles - Packet Service Profile

Use this object to specify Real Time Control Protocol (RTCP) options for the call. RTCP is used to report network traffic congestion data. Various actions (for example call disconnect) may be taken when congestion threshold settings are exceeded.

To View and Edit Rtcp Options

On SBC main screen, go to Configuration > Profile Management > Category: Media Profiles > Packet Service Profile > Rtcp Options.

Select the desired Packet Service Profile from the drop-down list to view its respective Rtcp Options parameters.

The Rtcp Options window is displayed.

Profile Management - Media Profiles - Packet Service Profile - Rtcp Options

The following fields are displayed:

Packet Service Profile - RTCP Options Parameters

ParameterDescription
Rtcp

RTCP is used to report network traffic congestion data. Various actions (for example call disconnect) may be taken when congestion threshold settings are exceeded. The options are:

  • enable — Use RTCP for the call.
  • disable (default)— Do not use RTCP for the call.
Termination For PassthroughSpecifies RTCP termination behavior for pass-through calls. The options are:
  • disable (default) — RTCP is relayed between the end points for pass-through calls.
     
  • enable — RTCP sessions for each leg are terminated by the SBC.

This parameter is visible only when Rtcp is enabled.

Packet Loss Threshold

Enter a value between 0-32767 to specify the Packet Loss Threshold (number of lost packets/100,000) which will trigger a Packet Loss Action. This parameter is required if RTCP is enabled. When set to “0”, no packet loss inactivity detection is performed. The value ranges from 0 to 32767 and the default value is 0. The value ranges from 0 to 32767 and the default value is 0.

Configuring this parameter to a value less than 400 disables threshold detection, so be sure to use a value in the range of 400 to 32767 to enable threshold detection.

This setting can be used in conjunction with   Media Peer Inactivity. To set media peer inactivity timeout value, see Media Peer Inactivity parameter in Media Peer Inactivity page.

For an example configuration of this parameter, see Packet Service Profile (CLI) page.

This parameter is visible only when Rtcp is enabled.

Packet Loss ActionSpecifies what Packet loss action to take when packet threshold is exceeded. The options are:
  • none — Take no action.
  • packetLossTrap — Generate trap.

  • packetLossTrapAndDisconnect — Generate trap and disconnect.

    This parameter is visible only when Rtcp is enabled.

Make the required changes and click Save at the right hand bottom of the panel to save the changes made.

 

  • No labels