You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

In this section:

Connecting the Power and Cables

The 

Unable to show "metadata-from": No such page "_space_variables"
 includes an AC power adapter for connecting to an AC outlet.

Caution

Always connect the AC power cord to an AC outlet suitable for the power supply that came with the unit to reduce the risk of damage.

Caution

Secure the AC power cord to a cable management system using a fastener or tie wrap to insure the EdgeMarc does not hang from the AC outlet.

  1. If you are connecting to an Internet router or Internet DMZ switch, connect the Ethernet cable to the WAN 1 Interface port on the EdgeMarc and the other end to the WAN device.
  2. Power on the system.
Warning

The equipment has a separate protective earthing terminal on the chassis that must be permanently connected to earth ground to adequately ground the chassis and protect the operator from electrical hazards.

Powering on the 
Unable to show "metadata-from": No such page "_space_variables"
 

  1. Connect the DC connector from the power adapter to power port on the EdgeMarc.
  2. Make sure that the power and status LEDs on the front panel are solid green after the EdgeMarc powers on.
  3. Proceed to Configuring Basic Network Settings.  

     

    .
  • No labels