You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Next »

 

 

 

In this section:

 

This describes

Unable to show "metadata-from": No such page "_space_variables"
hardware and software requirements and recommendations.

To install and configure

Unable to show "metadata-from": No such page "_space_variables"
, make sure the Virtual Machine (VM) host meets the following recommended hardware, server platform and software requirements.

 

The recommended hardware and software settings are intended to ensure optimum 

Unable to show "metadata-from": No such page "_space_variables"
stability and performance. If the recommended settings are not used, 
Unable to show "metadata-from": No such page "_space_variables"
system may not behave as expected.

 

 

License Requirements

You must obtain and apply a valid

Unable to show "metadata-from": No such page "_space_variables"
 license in order to configure and use the
Unable to show "metadata-from": No such page "_space_variables"
. See the instructions at Obtaining and Installing a SWe Lite Trial License.


Server Hardware Requirements

Server Hardware Requirements

Configuration Requirement
Processor2nd Generation Intel Core or Intel Xeon Processor (Sandy bridge or later)
RAMEach SWe Lite instance requires 1024 MB RAM
Drive Space
Hard disk requirements are dependent upon the number of VMs hosted, the size of each VM at full size, and whether checkpoints will be enabled.
Architecture64-bit Intel processor
Host OS
Red Hat Enterprise Linux 7.2 or newer

 


BIOS Setting Recommendations

Sonus recommends the following BIOS settings for optimum performance:

Recommended BIOS Settings for Optimum Performance

BIOS ParameterRecommended
Setting
Details
Intel VT-x (Virtualization Technology)EnabledFor hardware virtualization
Intel Hyper-ThreadingEnabled 

 

 

BIOS settings and recommendations must not be changed once it is applied on the server.

Sonus Recommendations for
Unable to show "metadata-from": No such page "_space_variables"

General Recommendations

  • Plan enough resources (RAM, CPU, NIC ports, hard disk, etc.) for all the virtual machines (VMs) to run on the server, including resources needed by the host server.
  • Allocate each VM with only as much virtual hardware as that VM requires. Provisioning a VM with more resources than it requires can, in some cases, reduce the performance of that VM as well as other virtual machines sharing the same host.
  • Disconnect or disable any physical hardware devices (Floppy devices, Network interfaces, Storage controllers, Optical drives, USB controllers, etc.) under BIOS settings that you will not be using to free up interrupt/CPU resources.

 

VM Configuration Recommendations

Setting 
vCPU1 supported
RAM

1 GB supported

vNIC

5

(Up to 3 may be disabled, if only a single vNIC is required for media. Note: One vNIC is mandatory for management.)

Virtual Hard Disk5 GB minimum
 

Additional Information

  • The SBC SWe Lite VM does not currently support allocation of more than one vCPU.
  • With minimum RAM allocation, the maximum SIP endpoint registrars is 1000, and the maximum number of concurrent calls is 100.
  • Minimal networking configuration requires the Management Network Interface and at least one Media Interface to be assigned.
  • Each SBC SWe Lite VM will use approximately 5GB of Virtual Hard Drive space. Drive size is predetermined by the imported image.

 

Refer to Downloading the SBC SWe Lite Package for software download instructions.

 

 

  • No labels