Page History
...
- In the WebUI, click the Settings tab.
In the left navigation pane, go to System > Software Management > Application Partitions.
Panel borderStyle none Caption 0 Figure 1 Partitions Table - Make note of the inactive partition number you are upgrading the firmware to (the table entry listed without a tick mark under the 'Active Partition' column)
This will be important towards the end when verifying the last upload status of the inactive partition. Click the Upload Firmware link located on the top right hand side of the pane - a popup window will be dispatched:
Panel borderStyle none Caption 0 Figure 1 Upload Firmware
5. Under Select File, click the Browse button and select the Sonus SBC 1000/2000 firmware file listed in the general Sonus SBC 1000/2000 Upgrade guide to upload. Click OK. Do not close or navigate away from the browser window or you may receive partial results.
| Panel |
|---|
...
|
...
| |||||||
|
...
6. Throughout the upload process, the web interface displays update messages to indicate the progression of the upgrade of the inactive partition, as shown below. (If you navigate to this view from another browser, it will also display the progress.)
| Panel |
|---|
...
|
...
| |||||||
|
...
| Info |
|---|
Under normal conditions, an average upgrade takes about 8 - 9 minutes. During the upgrade process, the remaining time estimates in the different steps becomes more accurate as the process progresses. |
...
Overview
Content Tools