Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.


Panel

In this section:

Table of Contents
maxLevel2



Info
iconfalse

Related articles:

Children Display



Excerpt

The 

Spacevars
0series
 applies disconnect treatment to the ingress party specified by the Signaling Sequence Profile (SSP). This SSP is derived from the SCP disconnect treatment profile (DTP) and disconnect treatment indicator provided by the PSX in a trigger response.

The DTP must be explicitly configured on

the

the 

Spacevars
0series
. The existing disconnect reason is still forwarded to the ingress party immediately after the disconnect treatment (if applicable) is applied. The disconnect reason can be SCP or egress party initiated.

To View Disconnect Signal Sequence Profile

On the SBC main screen, go

to

to Configuration

>

 > Profile Management

> Category

 > Category: Service

Profiles

Profiles > Disconnect Signal Sequence Profile.

The Disconnect Signal Sequence Profile window is displayed.

Figure 1: Profile Management - Service Profiles - Disconnect Signal Sequence Profile

Image Modified

To Edit Disconnect Signal Sequence Profile

To edit any of the Disconnect Signal Sequence Profile in the list, click the radio button next to the specific Disconnect Signal Sequence Profile name.

The Edit Selected Disconnect

The Edit Selected Disconnect Signal Sequence Profile window

is displayed below.You would not be able to edit as the field

is read-only.

To Create Disconnect Signal Sequence Profile

To create a new Disconnect Signal Sequence Profile,

click

click New Disconnect Signal Sequence Profile

tab

 tab on

the Disconnect

the Disconnect Signal Sequence Profile List panel.

Figure 2: Profile Management - Service Profiles - Disconnect Signal Sequence Profile Fields

Image Removed

The Create New Disconnect Signal Sequence Profile window is displayed.

Figure 3: Profile Management - Service Profiles - Disconnect Signal Sequence Profile Fields

Image Modified

The following fields are displayed:

Table 1:


Disconnect Signal Sequence Profile Parameters:

ParameterDescription
Name
Specifies the
The user name for this Disconnect Signal Sequence Profile.

To Delete Disconnect Signal Sequence Profile

To delete any of the created Disconnect Signal Sequence Profile, click the radio button next to the

specific Disconnect

specific Disconnect Signal Sequence Profile

which you want to delete

.

Click

Click Delete

at

 at the end of the highlighted row. A delete confirmation message appears seeking your decision.

Click Yes

Click Yes to remove the specific Disconnect Signal Sequence Profile from the list.