Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

The BMC web application allows provisioning of You can provision primary and secondary host management interfaces in the Baseboard Management Controller (BMC) web application. When the host management interfaces are configured, a direct link from the BMC is enabled to the EMA for installing and upgrading the

Spacevars
0series2
application.

...

  1. Logon to the SBC BMC GUI using the IP address configured in the previous section. The SBC BMC main screen appears.

    Caption0

    Figure1BMC Main ScreenImage Modified


  2. Navigate to Configuration > Platform Management Network tab. The Platform Management Network Settings screen is displayed.

    Caption
    0Figure
    1Configuration Screen

    Image Removed

    InfotitleNote

    Image Added
    Image Added



  3. A message appears to enter the management IP addresses for the first time installation.

     
    Caption
    0Figure
    1Warning Message

    Image Removed

    Click OK to continue.

    Image Added


  4. Configure the following network settings for

    both

    the Management Interface 0 and 1, then click Save.

    - IPv4 Address or/and IPv6 Address
    - Prefix
    - Default Gateway


    Click Save.

    Caption
    0Figure
    1Platform Management Network Settings

    Image Removed

    InfotitleNote

    When coming from an application software release prior to SBC 3.1.x, an IPv4-mapped IPv6 address is applied as an unusable placeholder in the IPv6 management address, this mapped address must be removed or set to a valid IPv6 address when updating the management addresses via BMC. 

Warning
titleWarning

Once you update a new Management IP address from the BMC and click Save, a warning message displays, informing you to reinstall the SBC application software.

If you update the Management IP using CLI/EMA or RAMP, the change will automatically update updates in the BMC, and an application re-installation is not required. 

...


Info

...

title
Noprint
Panel
bgColortransparent
borderWidth2

Continue to Configuring NTP Server Settings Using SBC 7000 BMC.

...

Note

When coming from an application software release prior to SBC 3.1.x, an IPv4-mapped IPv6 address is applied as an unusable placeholder in the IPv6 management address, this mapped address must be removed or set to a valid IPv6 address when updating the management addresses via BMC.