Page History

 

This section describes 

Spacevars
0 series3

 hardware and software requirements and recommendations.

To install and configure 

Spacevars
0 series3

, make sure the Virtual Machine (VM) host meets the following recommended hardware, server platform and software requirements.

 

Warning
icon false
The recommended hardware and software settings are intended to ensure optimum stability and performance. If the recommended settings are not used, the Spacevars 0 series3 may not behave as expected.

License Requirements

You must obtain and apply a valid

Spacevars
0 product3

 license in order to configure and use the 

Spacevars
0 product3

. See the instructions at Obtaining and Installing a SWe Lite Trial License.

Multiexcerpt
MultiExcerptName Hyper-V Hardware Requirements
Server Hardware Requirements   Caption 0 Table 1 Server Hardware Requirements Configuration  Requirement Processor 2nd Generation Intel Core or Intel Xeon Processor (Sandy bridge or later) RAM RAM requirements are dependent upon the number of VMs hosted, the memory assigned to each VM instance, and the relative overhead memory associated with each. Drive Space Hard disk requirements are dependent upon the number of VMs hosted, the size of each VM at full size, and whether checkpoints will be enabled. Architecture 64-bit Intel processor Host OS Microsoft Windows Server 2012   Minimum Hyper-V hosting requirements are posted by Microsoft. Info The SBC SWe Lite does not support execution within a Hyper-V cluster, as defined at technet.microsoft.com. Contact your Sonus sales representative if you have any questions.

 

BIOS Setting Recommendations

Sonus recommends the following BIOS settings for optimum performance:

Caption
0 Table 1 Recommended BIOS Settings for Optimum Performance
BIOS Parameter Recommended Setting Details Intel VT-x (Virtualization Technology) Enabled For hardware virtualization Intel Hyper-Threading Enabled

 

 

Note
icon false
BIOS settings and recommendations must not be changed once it is applied on the server.

Sonus Recommendations for

Spacevars
0 series3

General Recommendations

• Plan enough resources (RAM, CPU, NIC ports, hard disk, etc.) for all the virtual machines (VMs) to run on a server, including resources needed by Hyper-V itself.
• Allocate each VM with only as much virtual hardware as that VM requires. Provisioning a VM with more resources than it requires can, in some cases, reduce the performance of that VM as well as other virtual machines sharing the same host.

• Disconnect or disable any physical hardware devices (Floppy devices, Network interfaces, Storage controllers, Optical drives, USB controllers, etc.) under BIOS settings that you will not be using to free up interrupt/CPU resources.

Caption
0 Table 1 VM Configuration Recommendations
Setting Minimum vCPU 1 RAM 1 GBGiB vNIC 5 (Up to 3 may be disabled, if only a single vNIC is required for media. Note: One vNIC is mandatory for management.) Virtual Hard Disk 5 GBGiB

 

Additional Information

• The SBC SWe Lite VM does not currently support allocation of more than one vCPU.
• With minimum RAM allocation, the maximum SIP endpoint registrars is 1000, and the maximum number of concurrent calls is 100.
• The estimated Hyper-V overhead memory for each SBC SWe Lite VM is 32MB.
• Minimal networking configuration requires the Management Network Interface and at least one Media Interface to be assigned.
• Each SBC SWe Lite VM will use approximately 5GB 5 GiB of Virtual Hard Drive space. Drive size is predetermined by the imported image.

 

Info
icon false
Refer to Downloading the SBC SWe Lite Package for software download instructions.

 

Pagebreak