Page History

In This Section...

Overview

This Best Practice describes One Number Fax (ONF) feature configuration for the SBC Edge in

...

Configure One Number Fax

...

1. Log into the WebUI and navigate to Active Directory> Domain Controller.
   
   

2. Create an entry with your domain controller's IP or FQDN (with the Call Route DC type, relevant search scope, and an LDAP query attribute), as shown below:

   Panel
   borderStyle none
   Caption 0 Figure 1 Create Domain Controller Image Modified

    

   Navigate to Active Directory> Configuration and configure it as shown below:

   Panel
   borderStyle none
   Caption 0 Figure 1 Configure AD Image Modified

   Pagebreak

Step 2: Configure Transformation Tables

...

1. Log into the WebUI and navigate to Transformation.
   
   

2. Create a transformation entry to passthrough the Called Address/Number, and normalize the Redirecting Number as facsimiletelephonenumber using the AD integration.

   Panel
   borderStyle none
   Caption 0 Figure 1 Create Transformation Entry - AD in Call Route Image Modified

If AD is not intended to be used in Call Routes in your deployment:

1. Log into the WebUI and navigate to Transformation.
   
   

2. Create a transformation entry to passthrough the Called Address/Number as shown below.
   
   NOTE: In the example below, the endpoint extension numbers and the eUM Subscriber Number are 3xxx-.

    

   Panel
   borderStyle none
   Caption 0 Figure 1 Create Transformation Entry - Endpoint Extension and eUM Subscriber Image Modified

3. Log into the WebUI and navigate to Transformation.
   
   

4. Create a transformation entry to passthrough the Called Address/Number as shown below.
   
   NOTE: When a call is referred to the Fax Server by eUM, the request header does not contain an extension number. Therefore, this piece of transformation is needed for the calls going to Fax Server.

    

   Panel
   borderStyle none
   Caption 0 Figure 1 Create Transformation Entry - Fax Server by eUM Image Modified

   Pagebreak

Step 3: Configure Routing Tables

...

1. Log into the WebUI and navigate to the Call Routing Table.
   
   

2. Create the following two Call Routing Table Entries.
   
   In Fax Calls where the CNG tone will be detected, a second entry needs to be added in the table to route calls to FAX Server:

   Panel
   borderStyle none
   Caption 0 Figure 1 Create Fax Entry  Image Modified

   
   For Voice calls, there is no need for an entry to Fax Server, therefore we create a Route Table for one entry for number transformation:

   Panel
   borderStyle none
   Caption 0 Figure 1 Create Voice Entry Image Modified

   Pagebreak

Step 4: Create Action Configuration and Action Set

1. Log in to WebUI and navigate to Call Actions.
   
   

2. Configure an Action Configuration as shown below:

   Panel
   borderStyle none
   Caption 0 Figure 1 Configure Action Configuration Table Image Modified

   
   If you plan to utilize AD in Call Route, create an Action Set as shown below:

   Panel
   borderStyle none
   Caption 0 Figure 1 Use AD in Call Route Image Modified

    

   If you plan NOT to utilize AD in Call Routes, create an Action Set as shown below:

   Panel
   borderStyle none
   Caption 0 Figure 1 AD Not Used in Call Route Image Modified

   Pagebreak

Step 5: Configure Media List

1. Log into the WebUI. on to WebUI and navigate to Media List in navigation pane.
   
   

2. Create/Modify the Media List to have T.38 Media Profile and CNG Tone Detection enabled as shown below:

   Panel
   borderStyle none
   Caption 0 Figure 1 Media List Configuration Image Modified

   Pagebreak

Step 6: Create Signaling Group

...

SBC - Exchange UM

...

SBC - Fax Server

...

Licensing

Ensure DS1, SIP, and the Active Directory licenses are available in your node as shown below: