Page History

Once you have updated the inactive partition either by Upgrading the Inactive Partition – SBC Edge or by Uploading Firmware Patches, new software does not take effect until you activate newly updated partition. When you activate the partition, the system must reboot to boot from the desired partition. All configuration is preserved when you activate the partition.

...

1. In the WebUI, click the Settings tab.

2. In the left navigation pane, go to System > Software Management > Application Partitions.

   Panel
   borderStyle none
   Caption 0 Figure 1 Application PartitionsSBC 1K/2K Caption 0 Figure 1 SBC SWe Lite Image Added

3. Click the Set Active link in the row entry associated with the partition that you wish to activate.
   The inactive partition is the row entry listed without a tick mark under the 'Active Partition' column

4. You will be prompted to reboot the Sonus SBC Edge/SBC SWe Lite, click OK.
   
   

   Warning
   title ASM Behavior on Sonus SBC 1000/2000

   , click OK

   Reboot Operation

   Depending on your Spacevars 0 product (SBC) model, users with a built-in Working with the ASM and SBA may be impacted by this operation: Sonus SBC 2000 If the ASM is running, rebooting the SBC will cause the ASM to also reboot. If the ASM is shut down, rebooting the SBC will not restart the ASM. To bring the ASM back into operation, you must physically power off and power back on the SBC. Sonus SBC 1000 --- rebooting the SBC will not have an effect on the ASM.

   Panel
   borderStyle none
   Caption 0 Figure 1 Reboot Prompt

   Note
   It will take up to 15 seconds for the action to be processed, and you will not see any visible indication during this short period of time.

5. The following status message will be dispatched indicating that the system is rebooting off of the new partition

   Panel
   borderStyle none
   Caption 0 Figure 1 Status Message

    

    

...