Page History
...
| Noprint | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
| Panel | ||||
|---|---|---|---|---|
In this section:
|
Overview
| Tooltip | ||
|---|---|---|
| ||
|
The
| Spacevars | ||
|---|---|---|
|
| Anchor | ||||
|---|---|---|---|---|
|
| Caption | ||||
|---|---|---|---|---|
| ||||
Parts and Tools Required
- Electrostatic discharge (ESD) strap
- Replacement Bezel (if swapping out the Bezel)
| Note |
|---|
To prevent damage from electrostatic discharge, an ESD strap is provided in the accessory kit. See Connecting ESD Wrist Strap to install it. |
Removing/Replacing the Bezel
| Note |
|---|
| The Bezel can be removed with power applied to SBC chassis, hence do not shut down the SBC to remove the Bezel. |
Perform the following procedure to replace the Bezel:
Locate the tab on the left side of the Bezel and pull back on Bezel until the left ball stud mounts disengage from the chassis.
Caption 0 Figure 1 Locating the tab on the Bezel 
Caption 0 Figure 1 Disengaging Bezel from the SBC 5400 chassis 
Grasp the right-side of the Bezel and pull the Bezel away from the chassis until the right ball stud mounts disengage from the chassis.
Caption 0 Figure 1 Pulling out the Bezel from the chassis - Install the replacement Bezel assembly by aligning the ball stud mounts to the receiving sockets, and then gently push the Bezel until it is secured to the chassis.
CRU Storage
| Tooltip | ||
|---|---|---|
| ||
|
All
| Spacevars | ||
|---|---|---|
|
The storage environment for the CRUs are:
- Humidity must be less than 95% (non-condensing)
- Temperature must be between -40C and +70C
...
| Pagebreak |
|---|
Overview
Content Tools