Add_workflow_for_techpubs | ||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Include Page | ||||
---|---|---|---|---|
|
Panel | ||||||
---|---|---|---|---|---|---|
In this section:
|
Info | ||
---|---|---|
| ||
Related articles: |
After the OAM dashboard service activates, network operators must manually populate the Network Segment Table with IP address details. The Network Segment (NS) then retrieves the information from the Network Segment table (NST) through the config-agent.
The NS maintains the IP association details in a table termed Network Service Association table (NSAT), which is used during the switchover, or when the pod re-requests for an IP address using the same name.
On the SBC main screen, navigate to All > System > Network Segment Table.
Network Segment Table
Parameter Descriptions
To create a new Network Segment Table:
Configure the fields by referring to the table below and then click Save:
Parameter | Length/Range | Description |
---|---|---|
Name | 1-23 | The Network Segment Table name for the system. |
Network Segment Type | N/A | The network segment type for this configuration.
|
|
| ||
Pfe ID | N/A |
Packet Frontend ID to which the network segment is anchored. |
VLAN ID | 2 - 4094 | The VLAN TAG assigned to this Network Segment Table. |
Network Interface Name | N/A |
Select the network interface:
| ||
Prefix V4 | 0 - 32 | The IPv4 prefix for this Network Segment Table. |
Prefix V6 | 0 - 128 | The IPv6 prefix for this Network Segment Table. |
State
N/A
Administrative state of the Network Segment Table.
Changes are only made while disabled and will take effect when enabled.
Port Ranges - Name | Up to 23 characters | Assign a name for the port range. |
Port Ranges - Range Start | 1 - 65535 | Assign a starting port for the port range. |
Port Ranges - Range End | 1 - 65535 | Assign an ending port for the port range |
Port Ranges - Transport | N/A | Select the appropriate transport type: TCP or UDP |
Port Ranges - Application Type | N/A | Application type used for portRange signaling, media, and signalingGateway.
|
To create a new Network Segment Table:
Start
Use the following table when configuring the fields and then click Save.
Parameter | Length/Range | Description |
---|---|---|
Name | 1 - 23 | The Network Segment Table name for the system. | Network Segment Type | N/A |
Include Page | _PFE_not_supported_in_12.1.1 | _PFE_not_supported_in_12.1.1 |
Available_since | ||
---|---|---|
|
The name of the primary and secondary network.
Note: This parameter is OAM specific.
Enter the network interface:
0 - 32
The IPv4 prefix for this Network Segment Table.
0 - 128
To edit the Network Segment Table:
Start
To delete the Network Segment Table:Start