Page History

This page describes how to configure SNMP on Sonus SBC 1000/2000 and the

Step 1 - Configuring SNMP on

...

the SBC

The

Sonus SBC 1000/2000 SNMP Management Address Table entry should be created and configured with following information:

• SNMP Manager Address: IP address or the FQDN of the SNMP manager when a MIB browser is running.
• Community: Enter a desired community name. In this exercise we use public as the community name.
• Community Type: Must be set to Read-only.
• Trap Enabled: Not required but for this exercise we are setting it up as True.
  
  

Step 2 - Installing an SNMP Management Client

There are a various number of MIB Browsers available to download and use on the internet. For this exercise, we will be using a free edition of the iReasoning MIB Browser.

...

1. On a PC that is dedicated to be the SNMP Manager download iReasoning MIB Browser and install using the default settings.
2. Launch iReasoning from the start menu.
3. Click the Advanced...button as shown below and enter the following information:
   • Address: IP Aaddress of Sonus SBC 1000/2000the 

     Spacevars
     0 product2

   • Port: Keep the default value (161)
   • Read Community: public
   • Write Community: Leave it blank

   • SNMP Version:2

     Panel
     borderStyle none
     Caption 0 Figure 1 Install SNMP Management Client

Step 3 - Start Managing

...

SBC

...

via SNMP

To start managing Sonus SBC 1000/2000 via SNMP, we'll need to load Sonus SBC 1000/2000the 

1. Download the MIB files located on the SNMP MIBs Reference page.

2. In the iReasoning MIB Browser, click the File menu and select Load MIBs.

   Panel
   borderStyle none
   Caption 0 Figure 1 Load MIBs

3. Browse to location where you saved the MIB files obtained in the initial step.

4. Select all MIB files and hit click Open.

   Panel
   borderStyle none
   Caption 0 Figure 1 Open Files

Traps include both alarms and events. If you want to receive Trap for alarms and events from Sonus SBC 1000/2000the

1. In the iReasoning MIB Browser, click the Tools menu item and select Trap ReceiverReceiver as shown below:

   Panel
   borderStyle none
   Caption 0 Figure 1 Trap Receiver

2. Click Trap Filter, add the IP address of Sonus SBC 1000/2000 node, and hit click OK.

   Panel
   borderStyle none
   Caption 0 Figure 1 Trap Filter

3. Navigate to the private private folder* navigation pane to see the relevant Sonus SBC 1000/2000 MIBs as shown below:

   Panel
   borderStyle none
   Caption 0 Figure 1 Private Folder Navigation Pane

   Pagebreak