Page History

In any SIP call scenario, two entities are involoved in the call flow: UAC and UAS. In this exercise, PSTN makes a call to the Lync client over the Sonus SBC 1000/2000, where the Sonus SBC 1000/2000

Spacevars
0 product

, where the 

Spacevars
0 product

acts as a UAC and the Lync/SBA acts as a UAS. In our example we are assuming that a Sonus SBC 1000/2000 a 

Spacevars
0 product

is integrated in the topology shown below.

This article describes the steps necessary to configure a Sonus SBC 1000/2000 a 

Spacevars
0 product

to employ the SIP Timer Functionality in the depicted topology:

Configuration

...

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to SIP > SIP Profiles
3. Select the relevant SIP Profile.

4. Configure the Session Timer as shown in the figure below.
   Important: The Offered Session Timer value must be equal to or greater than the Minimum Acceptable Value.

   Panel
   borderStyle none
   Caption 0 Figure 1 Configure Session Timer Image Modified

Signaling Group

1. In the WebUI, click the Settings tab.
2. In the left navigation pane, go to Signaling Groups > (relevant SIP Signaling Group).
3. Select the SIP Profile configured above from the SIP Profile selection list.

4. Click Apply

   Panel
   borderStyle none
   Caption 0 Figure 1 Apply Configured SIP Profile Image Modified

Call Flow

After having applied the configuration changes, in the call flow, the Sonus SBC 1000/2000 the 

Spacevars
0 product

supports the UPDATE and INVITE  methods for changing the media capabilities. Session Timer (RFC 4028) uses the INVITE or UPDATE as a mechanism for a periodic refresh of SIP sessions.

Currently the Sonus SBC 1000/2000 the 

Spacevars
0 product

supports RTCP-based dead call detection. Session timers provide an alternate methodology for the detection of dead calls using SIP Signaling. If the SIP peer fails to respond to an UPDATE or INVITE message, this enhancement cleans up the call by sending a BYE which will enable the call stateful SIP proxies (Lync/SBA in this example) to clean up the resources associated with the call. Additionally, the relevant DISCONNECT is sent to the PSTN link by the Sonus SBC 1000/2000

Spacevars
0 product

.

You can verify this using the Log Exchange utility — the following diagram depicts a Sonus SBC 1000/2000 a 

Spacevars
0 product

to Lync/SBA call with the Session Timer enabled and in effect:

Panel
borderStyle none
Caption 0 Figure 1 SBC 1000/2000 to Lync/SBA Call Image Modified

Pagebreak