Page History
Add_workflow_for_techpubs | ||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
The following workflow defines the procedures for upgrading an SA NLL SWe Edge to an HA NLL SWe Edge in a non-RAMP scenario.
...
Log in to your SBC SWe Edge instance.
Click the Settings tab at the top of the WebUI.
In the left navigation pane, go to System > Node-level Settings.
Click Enable HA.
Enable HA on SBC SWe Edge InstanceEnter the Local IP Address, Local IP Netmask, and Remote IP Address in the Create HA Interface pop-up window.
Info title Note The Local IP is the HA IP address of the instance you are currently in. The remote IP is the other HA IP address for the other example, as mentioned in the prerequisites section.
Create an HA Interface on the Instance- You will be prompted with the below confirmation. Click on OK to continue.
Click OK. The instance will reboot for about 2 minutes until it displays the HA interface.
HA Interface on the Active Instance
Confirm that HA is enabled on this instance. The HA role of the instance is seen in the right-hand corner of the WebUI.
The HA Role is Shown at the Right Hand Corner of the Instance WebUI
Repeat steps 1 to 7 in the second instance, becoming the Standby.
...