10/100/1000 Mbps RJ-45 Ethernet port for LAN network connectivity.
Default IP: 192.168.1.1
2
Port 2
WAN 1
10/100/1000 Mbps RJ-45 Ethernet port for connectivity to the WAN or Internet network connectivity.
Default IP: None
3
Port 3
Mgmt
10/100/1000 Mbps RJ-45 Ethernet port for optional management network connectivity. This interface must not be on the same network as the WAN or LAN subnets. This network cannot be within a subnet contained in a “Route” statement.
4
Port 4
WAN 2
Secondary WAN Interface Port. 10/100/1000 Mbps RJ-45 Ethernet port for connectivity to the WAN or Internet network connectivity.
The port is covered with a removable RJ-45 cap. Remove the cap before use.
Supports basic routing in addition to the following:
• Dual WAN Port feature—Two discrete WAN interfaces with the ability to independently route
• WAN failover / WAN Link Redundancy (WLR)
• Link aggregation for WAN acceleration
Note: This port is unused if you are running a software release prior to 13.11.2.
5
Port 5
LAN 2
10/100/1000 Mbps RJ-45 Ethernet port for LAN network connectivity.
Default IP: 192.168.1.1.
The port is covered with a removable RJ-45 cap. Remove the cap before use.
Note: This port is unused if you are running a software release prior to 13.12.
6
Port 6
LAN 3
10/100/1000 Mbps RJ-45 Ethernet port for LAN network connectivity.
Default IP: 192.168.1.1.
The port is covered with a removable RJ-45 cap. Remove the cap before use.
Note: This port is unused if you are running a software release prior to 13.12.
7
Erase
Erase button
Press the Erase button in quick succession to control the following:
One click—No action.
Two clicks—Resets the CLI password
with no service interruption
to what is stored in the manufacturing configuration.
Three clicks—Restores to factory default settings and reboots the system.
Info
title
Note
:
When restored to factory default settings, the current configuration is lost, disconnecting all VoIP devices, Internet connectivity, and network access for computers until the system is reconfigured.
Info
title
Note
If the Erase button is disabled (as noted on the Admin page of the GUI) and you wish to reset the password, please contact the Global Support Assistance Center: