Use the Media RTCP Control window to configure RTCP session parameters for the system.
On the
This object is used to configure sender report interval.
On SBC main screen, go to All > System >Media > Media Rtcp RTCP Control. The Media Rtcp Control RTCP Control window is displayedopens.
| Caption |
|---|
| 0 | Figure |
|---|
| 1 | System - Media - Media Rtcp Control |
|---|
|
 Image Modified
|
The following fields are displayed:Use the following table to configure the options and then click Save.
| Caption |
|---|
| 0 | Table |
|---|
| 1 | Media RTCP Control Parameters |
|---|
|
| Parameter | Description |
|---|
| Sender Report Interval | Specifies the RTCP SR (sender report) interval when RTCP is terminated by NP. | When RTCP termination is enabled in the Packet Service Profile, this value specifies the initial interval for generating the sender/receiver report. The allowed range is between 5 and 120 seconds. The default value is 5. | | Send BYEPacket | When RTCP termination is enabled in the Packet Service Profile, this option specifies whether or not to send RTCP BYE packets when calls are terminated. The options are: - Disabled – Use this setting to suppress RTCP BYE packets in pass-through scenarios when the RTCP
terminationForPassthrough option is enabled and the call is not established. This setting is useful to avoid one-way audio when Dynamic LRBT and RTCP are in use at the same time. - Enabled (default) – the SBC sends an RTCP BYE packet when a call is terminated. This setting affects all calls configured with RTCP termination.
|
|
Make the required changes and click Save at the right hand bottom of the panel to save the changes made.