Page History
...
- In the mounting hardware bag provided with the
system, find the rear support brackets (2) and 9-inch extension arms (2).Spacevars 0 series2 - If you are installing the
system into a 30-inch depth rack, attach the extension arms to the support brackets.Spacevars 0 series2 Attach the support brackets securely to the two rear posts of your equipment rack. Refer to the illustration below for visual details of the assembly:
Panel bgColor #FFFFFF borderStyle none Caption 0 Figure 1 Assemble and Install Rear Support Brackets
Note |
---|
The illustration above shows the rear bracket assembly for a rack with a 30-inch depth. For racks with a 24-inch depth, do not use the 9-inch extension arm and attach each support bracket directly to the rear rack posts. |
...
- Attach the 2 rack mounting ears securely to the front corners of the
chassis.Spacevars 0 series2 - Attach the 2 pan handle plates securely to the rear corners of the
chassis.Spacevars 0 series2 - Working with a partner, lift the
chassis and slide it into the equipment rack, making sure to seat each pan handle plate into the support brackets mounted on the rear support posts.Spacevars 0 series2 Attach the 2 rack mounting ears securely to the front mounting posts of the equipment rack. Refer to the illustration below for visual details of the installation (click to enlarge).
Panel bgColor #FFFFFF borderStyle none Caption 0 Figure 1 Install in 4-Post Equipment Rack
Warning | ||||
---|---|---|---|---|
Do not block the air vents on either side of the
|
...
- Attach the 2 rack mounting ears securely to the center mounting points on both sides of the
chassis.Spacevars 0 series2 Attach the 2 rack mounting ears securely to the mounting posts of the equipment rack. Refer to the illustration below for visual details of the installation (click to enlarge).
Panel bgColor #FFFFFF borderStyle none Caption 0 Figure 1 Install in 2-Post Equipment Rack
Installing Interface Cards
...
Warning | ||||
---|---|---|---|---|
You must power down the |
Wiki Markup |
---|
{multi-excerpt-include:pageTitle=Inserting and Removing Interface Cards|name=insert|nopanel=true} |
Pagebreak |
---|
Installing Ground Wire, Power Cables and Connect Power
...
Place the cable management bracket on top of the pan handle plates.
Note If you have installed the
chassis in a 2-post configuration, you must install the pan handle plates on the rear corners of the chassis.Spacevars 0 series2 Use the provided cable ties to secure the cable management bracket to the pan handle plates. Refer to the illustration below for visual details of the installation (click to enlarge).
Pagebreak Panel bgColor #FFFFFF borderStyle none Caption 0 Figure 1 Install Cable Management Bracket
Warning | ||||
---|---|---|---|---|
DO NOT INSTALL EITHER RIBBON or TELECOM CABLES. You must complete the Initial Configuration before connecting the |
Next Steps
You are now ready to complete the initial configuration of the
Spacevars | ||
---|---|---|
|
Pagebreak |
---|