Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

 

Add_docset_workflowAPPRJIDSYM-21010AUTH1DEV1LDEV1SVT1LSVT1AUTHJIDSYM-20480The Sonus SBC 1000 requires that you explicitly configure each Ethernet port. At least one IP address must be configured and it is not necessary to the other two IP addresses. When configuring IPv4 interfaces or IPv4/IPv6 interfaces, an optional Secondary IP address may also be configured on the Ethernet port (this option is not available for IPv6 interfaces only).

...

  1. In the WebUI, click the Tasks tab.

  2. In the left navigation pane, under the IP Protocols, click Modify Ethernet IP Address.

    Panel
    borderStylenone
    Caption
    0Figure
    1Modify Ethernet IP

    Image Modified

     

     

  3. Modify the Ethernet 1 IP Setup information as necessary (if required, modify the Ethernet 2 IP Setup and Ethernet 3 IP Setup information).

    Info

    For Ethernet 1 IP Setup, the example shows the IP Addressing Mode set at Both (IPv4 and IPv6).

  4. Modify the Default IP Route information as necessary.

...