Panel | ||||
---|---|---|---|---|
In this section:
|
Excerpt | ||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
The SBC, like other
|
The supported configurable SNMP trap types are SNMP v1, v2, and v3.
The following command is executed in CLI to configure the SNMP traps:
Code Block |
---|
% set oam snmp trapTarget myTarget ipAddress <ip address> state enabled |
Multiexcerpt include | ||||||
---|---|---|---|---|---|---|
|
Refer to the
Spacevars | ||
---|---|---|
|
Perform the following steps to create a view:
Select Fault Manager from the Network Mgmnt roll-up (left hand side of the Users & Roles window). The Fault Manager window appears.
Caption | ||||
---|---|---|---|---|
| ||||
|
In the Bars option, select Create.
Caption | ||||
---|---|---|---|---|
| ||||
Click Save. The view is saved and displayed in the left side pane.
Caption | ||||
---|---|---|---|---|
| ||||
|
Perform the following steps to view the traps:
Select the view from the Views drop-down menu. Click Open. The view is displayed.
Caption | ||||
---|---|---|---|---|
| ||||
|
Double-click the Total Events bar. The Event Names appear for the selected device.
Caption | ||||
---|---|---|---|---|
| ||||
|
Perform the following steps to clear a trap:
Select the trap to be cleared.
Caption | ||||
---|---|---|---|---|
| ||||
Select Clear from the Operations drop-down menu. The trap is cleared from the list.
Caption | ||||
---|---|---|---|---|
| ||||
The SBC supports following generic SNMP traps apart from the application specific traps or alarms:
The traps are triggered under specific conditions. For detailed information about these traps, refer to the relevant Trap page using the links provided in the table below.
Caption | ||||||||||
---|---|---|---|---|---|---|---|---|---|---|
| ||||||||||
|
Pagebreak |
---|