Versions Compared

Old Version 1

changes.mady.by.user Ribbon Communications

Saved on

compared with

New Version Current

changes.mady.by.user Ribbon Communications

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Noprint
Panel
borderColorgreen
bgColortransparent
borderWidth2

Back to Table of Contents

Back to Installing SBC 5000 and 7000 Series Software

Back to Software Installation Overview

This following diagram shows a high-level flow of the 

Spacevars
0series
and
Spacevars
0series2
installation sequence, from rack mounting the SBC chassis
Spacevars
0product
 chassis to placing your first call.

Caption
0Figure
1Installation Sequence

Image Modified

Click a link below to go to an installation task based upon your SBC type

Spacevars
0product
 type and configuration options:

  1. Rack mount the chassis:
    1. Rack Mounting the SBC 5000 Series Chassis
    2. Rack Mounting the SBC 7000 Series Chassis

  2. Connect Ethernet and data cables:
    1. Connecting SBC 5000 Series Ethernet and Data Cables
    2. Connecting SBC 7000 Series Ethernet and Data Cables

  3. Connect power to SBC and power on:
    1. Connecting Power to SBC 5000 Series and Powering On
    2. Connecting Power to SBC 7000 Series and Powering On

  4. Upgrade BMC firmware (if required):
    1. Upgrading SBC 5000 Series Firmware
    2. Upgrading SBC 7000 Series Firmware

  5. Configure SBC platform (BMC, management interfaces, NTP):
    1. Configuring the SBC 5000 Series Platform
    2. Configuring the SBC 7000 Platform

  6. Install SecureLink for Remote Access

  7. Install SBC Application Software
  8. Installing SBC Application - ERE Configuration
    -or-
    9. Installing SBC Application - ePSX Configuration

  9. Configure SBC for a basic call flow and make first call

...