...
add_ |
---|
...
workflow_for_ |
---|
...
techpubs | |
---|---|
|
...
Noprint | |||||||||
---|---|---|---|---|---|---|---|---|---|
|
|
Panel |
---|
In this section... |
...
|
The
...
Spacevars
...
0
...
performance metrics for simultaneous sessions product2
...
for various call scenarios are summarized in the "Benchmarking Results" section
...
of the following pages. Note that these numbers apply to our recommended CPU and memory configurations, and the results may vary depending on the actual CPUs used. Exceeding these simultaneous sessions metrics
...
may result in poor call performance, including longer call setup times and/or poor voice quality.
...
recommends maintaining call rates within the performance limits Spacevars 0 company
...
benchmarked
...
...
below.
...
Caption | ||||
---|---|---|---|---|
| ||||
|
Noprint |
---|
Caption | ||||
---|---|---|---|---|
| ||||
|
...
...
Div | ||||||
---|---|---|---|---|---|---|
| ||||||
|
|
...
|
...
|
...
|
...
|
...
|
...
|
...
|
...
|
...
...
|
...
|
...
|
...
|
...
* Intel I-350
Noprint |
---|
...
|
The two test beds used to collect benchmarking data are depicted below.
Info |
---|
The VM is hosted on a single NUMA node, where the NIC is connected. |
Caption | ||||
---|---|---|---|---|
| ||||
Caption | ||||
---|---|---|---|---|
| ||||
|
This section includes benchmarking results using the following configurations with and without DoS.
...
Contact your
representative if you are interested in benchmarking data for other call scenarios. Spacevars 0 company
...
Expand | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Without DoS
With DoS
|
...
Multiexcerpt include | ||||
---|---|---|---|---|
|
Multiexcerpt include | ||||
---|---|---|---|---|
|
The following tables define the amount of VM memory required based on the call capacity expected and the configuration requirements.
Info | ||||||||
---|---|---|---|---|---|---|---|---|
| ||||||||
The
|
Info | ||
---|---|---|
| ||
The SBC SWe requires a minimum memory size of 10 GB. |
Info | ||
---|---|---|
| ||
The SBC SWe requires a minimum memory reservation of 10 GB. |
...
Call Scenario/Configuration | Total Bandwidth (Mbps) | CPS/CHT | Simultaneous Sessions | DoS Bandwidth (Mbps) |
---|---|---|---|---|
G.711 pass-through | 817.78 | 25/360 | 9,000 | 0 |
G.729AB pass-through | 449 | 25/800 | 20,000 | 0 |
G.729 to G.711 transcoded | 31.76 | 2/417 | 834 | 0 |
G.729AB pass-through sessions,TLS/SRTP enabled on Ingress | 527 | 25/800 | 20,000 | 0 |
G.711 pass-through sessions,TLS/SRTP enabled on Ingress | 852.83 | 25/360 | 9,000 | 0 |
Direct Media | 198/102 | 20,196 | 0 |
Caption | |||
---|---|---|---|
|
...
| ||||||||||
|
Caption | |||
---|---|---|---|
|
...
|
...
Call Scenario/Configuration | Total Bandwidth (Mbps) | CPS/CHT | Simultaneous Sessions | DoS Bandwidth (Mbps) |
---|---|---|---|---|
G.711 pass-through | 950.45 | 25/360 | 9,000 | 133.07 |
G.729AB pass-through | 949 | 25/800 | 20,000 | 500 |
G.729 to G.711 transcoded | 942 | 2/417 | 834 | 910 |
G.729AB pass-through sessions,TLS/SRTP enabled on Ingress | 949.61 | 25/720 | 18,000 | 475 |
G.711 pass-through sessions,TLS/SRTP enabled on Ingress | 950.01 | 25/360 | 9,000 | 97.18 |
Direct Media | 953.67 | 198/102 | 20,196 | 953.67 |
...
| ||||||
|
Include Page | ||||
---|---|---|---|---|
|
Use the following procedure to increase RAM size on active (live) systems to meet the desired SBC SWe session capacity.
Step | Action |
---|---|
1 | Power down the designated standby SBC. |
2 | Increase the RAM size of the VM system, and then power-on the standby SBC. |
3 | Perform a manual switchover, and then power-down the previously active SBC. Refer to the following pages for details: EMA: System - Admin CLI: Admin - CLI |
4 | Increase the RAM size of the VM system for the powered-down SBC, and then power it back up. |
5 | Manually switchover to revert the active/standby SBCs back to their original states prior to beginning this procedure. |
6 | Follow LSWU steps if you are upgrading to the next release. |
Expand | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Without DoS
With DoS
Maximum Initial (challenged) REGISTER Rate for Config-3The following table lists the maximum initial (challenged) REGISTER rate with background load on SWe under Large configuration VM.
|
...
Expand | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Without DoS
With DoS
|
...
Expand | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
Without DoS
With DoS
|
...
Pagebreak |
---|