...
- In the WebUI, click the Settings tab.
- In the left navigation pane, go to SIP > SIP Profiles
- Select the relevant SIP Profile.
Configure the Session Timer as shown in the figure below.
Important: The Offered Session Timer value must be equal to or greater than the Minimum Acceptable Value.
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Configure Session Timer |
---|
| Image Modified |
|
Signaling Group
- In the WebUI, click the Settings tab.
- In the left navigation pane, go to Signaling Groups > (relevant SIP Signaling Group).
- Select the SIP Profile configured above from the SIP Profile selection list.
Click Apply
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Apply Configured SIP Profile |
---|
| Image Modified |
|
Call Flow
After having applied the configuration changes, in the call flow, the Sonus SBC 1000/2000 supports the UPDATE and INVITE methods for changing the media capabilities. Session Timer (RFC 4028) uses the INVITE or UPDATE as a mechanism for a periodic refresh of SIP sessions.
...
You can verify this using the Log Exchange utility — the following diagram depicts a Sonus SBC 1000/2000 to Lync/SBA call with the Session Timer enabled and in effect:
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | SBC 1000/2000 to Lync/SBA Call |
---|
| Image Modified |
|