...
Deck of Cards |
---|
|
Card |
---|
| Configure the public IP address 10.51.100.89 in the Sonus SBC 1000/2000. In the WebUI, access Tasks and select Modify Ethernet IP Address. Panel |
---|
| Caption |
---|
0 | Figure |
---|
1 | Modify Ethernet IP |
---|
| Image Modified |
|
Note that LAN Port 1 134.56.225.202 is already configured on the node which you'd be using to URL into WebUI. Following screenshot depicts the verification of LAN 1 configuration: |
Card |
---|
| Configure the public IP address of 10.51.100.89 in theSonus SBC 1000/2000. In the WebUI, access Tasks and select Modify Ethernet IP Address. Panel |
---|
| Caption |
---|
0 | Figure |
---|
1 | Modify Ethernet IP |
---|
| Image Modified |
|
|
|
Transformation Table
There are 4 different transformations used in this exercise:
Translation table for OCS (1xxx) extensions
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | 1xxx Transformation |
---|
| Image Modified |
|
Translation table for LAN-1 (2xxx) extensions
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | 2xxx Transformation |
---|
| Image Modified |
|
Translation table for LAN-2 (5xxx) extensions
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | 5xxx Transformation |
---|
| Image Modified |
|
Translation table for PSTN (3xxx) extensions
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | 3xxx Transformation |
---|
| Image Modified |
|
Call Routing Tables
There are 3 different Call Routing Table entries used in this exercise:
Routing Calls from OCS Endpoints
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Routing Calls From OCS Endpoints |
---|
| Image Modified |
|
Routing Calls from Multiple IP Endpoints (LAN-1 and LAN-2 endpoints)
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Routing Calls From Multiple IP Endpoints |
---|
| Image Modified |
|
Routing Calls from PSTN Endpoints
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Routing Calls From PSTN Endpoints |
---|
| Image Modified |
|
Signaling Groups
Signaling Groups for OCS
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Signaling Groups For OCS |
---|
| Image Modified |
|
Signaling Groups for LAN-1 endpoints
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Signaling Groups For LAN-1 Endpoints |
---|
| Image Modified |
|
Signaling Groups for LAN-2 endpoints
...
If there is no NAT device between Sonus SBC 1000/2000 and the SIP-trunking peer, then NAT Traversal must be set to NONE as shown below:
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Signaling Groups For LAN-2 Endpoints |
---|
| Image Modified |
|
Signaling Group for PSTN endpoints
Panel |
---|
|
Caption |
---|
0 | Figure |
---|
1 | Signaling Group For PSTN Endpoints |
---|
| Image Modified |
|