Page History

Add_workflow_for_techpubs

AUTH2	UserResourceIdentifier{userKey=8a00a0c8613a801e016167f8a31a002b, userName='null'}
AUTH1	UserResourceIdentifier{userKey=8a00a0c862eadf5e0163170affe7001b, userName='null'}
JIRAIDAUTH	CHOR-10741
REV5	UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb8305e98a00a02355cd1c2f0155cd26cd5909df, userName='null'}
REV6	UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cd5909df, userName='null'}
REV3	UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26cb230570, userName='null'}
REV1	UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26ca2f03d1, userName='null'}	REV2	UserResourceIdentifier{userKey=8a00a02355cd1c2f0155cd26c9b903048a00a02355cd1c2f0155cd26cb230570, userName='null'}

The following workflow defines the procedures for upgrading an SA NLL SWe Edge to an HA NLL SWe Edge in a non-RAMP scenario.

...

Log in to your SBC SWe Edge instance.
Click the Settings tab at the top of the WebUI.
In the left navigation pane, go to System > Node-level Settings.
Click Enable HA.

Enable HA on SBC SWe Edge Instance
Enter the Local IP Address, Local IP Netmask, and Remote IP Address in the Create HA Interface pop-up window.

Info
title Note
The Local IP is the HA IP address of the instance you are currently in. The remote IP is the other HA IP address for the other example, as mentioned in the prerequisites section.

Create an HA Interface on the Instance
You will be prompted with the below confirmation. Click on OK to continue.
Click OK. The instance will reboot for about 2 minutes until it displays the HA interface.
HA Interface on the Active Instance
Confirm that HA is enabled on this instance. The HA role of the instance is seen in the right-hand corner of the WebUI.
The HA Role is Shown at the Right Hand Corner of the Instance WebUI
Repeat steps 1 to 7 in the second instance, becoming the Standby.

...

Space shortcuts